User manual SMEG WMI16AAA

[. . . ] INTEGRATED WASHING MACHINE INSTRUCTIONS MANUAL EN 1 EN Contents 1. Control panel symbols 3 4 7 14 18 24 26 28 This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. [. . . ] It stays on while spin speed is being selected with the relative button. During the heating cycle, this LED indicates that the programme is in the washing water heating phase. C Time remaining shown on display LED D Spin speed shown on display LED Heating phase LED E F Display The display shows the following information: 1. time remaining for the selected programme, given in hours/minutes. The stated value is an estimate based on the machine's normal operating parameters (size of load, incoming water temperature, etc. ). The program time may therefore be a few minutes longer or shorter than stated here. delayed start (for models featuring this option). When the time remaining before the programme starts is less than 60 minutes, this information is given in minutes/seconds. error codes To find out which of the first 3 pieces of information are shown on the display, check which of the LED's, C, D, or N (the latter for models featuring the delayed start option) is lit. G Select spin speed button or Press the button repeatedly to select the required spin speed. The following spin speeds are available: stop with tub full · 0000: spin disabled and stop with tub full. The machine does not perform the final spin and ends the washing programme with water in the tub. To drain the water, see the explanations shown in paragraph 5. 14 from 600 rpm to the maximum speed indicated for the model: for cotton and coloured programmes, speed increases by 100 rpm starting from 600 rpm up to the maximum speed indicated for the model from 600 to 900 rpm: for synthetics, delicates and woollens programmes, speed increases by 100 rpm starting from 600 rpm up to 900 rpm. · · 15 EN H Options buttons Quick wash Button The options that may be available on the washing machine are shown below. This button reduces the overall duration of the washing cycle. This option is used to wash small loads or less dirty washing in less time. The bleach stage is skipped when the Quick Wash button is pressed (for models with bleach function). This washing machine is programmed to use a certain quantity of water and consume a certain amount of power considered to be sufficient for a normal washing cycle. Only press this button for specific requirements, e. g. : for very delicate fabrics (curtains or wool). The water level for washing and rinsing rises and power consumption for heating increases. Increase water button Easy-iron button This option reduces creasing on garments at the end of the programme. The machine performs a more delicate spin cycle and moves the garments at the end of the programme. Spin speed for all programmes is 600 rpm. Press this button for cottons programmes, the machine will perform an extended wash at 35°C (biological step) thereby offering good washing performance combined with power saving. The machine then continues the cycle at the selected temperature. N. B. : Press the economy cycle button to obtain a maximum washing temperature of 60° C and the elimination of the pre wash cycle. Economy cycle button - e Extra Rinse button In areas with soft water or to improve rinsing, press this button (optional for intensive programmes) to enable the extra rinse function (about 20% more water). Delicates button Press this button to reduce movement of the drum and, consequently, of the washing. Suitable for particularly delicate garments (shirts, silk, curtains, etc. ) Half load button 1/2 If the machine is used with a smaller amount of washing than that indicated in the "Programme Chart", press this button to save water, detergent and electricity. This option should not be used for synthetics or woollens. [. . . ] If the machine does not work, before calling the Service Centre and spending money unnecessarily, check that the operations indicated in this troubleshooting table have been performed. 1 The machine does not start Check that: 2 The tub does not fill with water the plug is correctly fitted into the socket the door is securely closed the "Start-Pause" button has been pressed. the plug is correctly fitted into the socket the door is securely closed the water tap is open the water inlet filters are not clogged. Clean them as indicated in paragraph 6. 5. [. . . ]