User manual SMEG WT110.2

[. . . ] This is to avoid the formation of flammable gas/ air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit. The quantity of the refrigerant used in your appliance is indicated on the rating plate. WARNING: Keep ventilation openings in the appliance's cabinet or in the built-in structure clear of obstruction WARNING: Do not use other mechanical devices or other means to accelerate the defrosting process than those recommended by the manufacturer WARNING: Do not damage the refrigerant system WARNING: Do not use electrical appliances inside the refrigerated storage compartment, unless they are of a type recommended by the manufacturer WARNING: Do not expose the appliance to rain WARNING: This appliance is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible person to ensure that they can use the appliance safely. Young children should be supervised to ensure that they do not play with the appliance Always keep the keys in a separate place and out of reach of children Before servicing or cleaning the appliance, unplug the appliance from the mains or disconnect the electrical power supply If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard Relevant for Australia: Supply cord fitted with a plug complies with AS/NZS 3112. [. . . ] The green lamp lights up to indicate that power is supplied. The red lamp on the control panel will also light up to indicate that the temperature inside the freezer is not yet sufficiently low. Acoustic alarm Temperature setting The temperature is set by turning the thermostat knob from MIN to MAX. It is recommended that a coin be used to turn the knob. The more the thermostat knob is turned towards MAX, the lower the temperature. To test whether the setting is correct, measure the temperature of the uppermost item in the centre of the freezer. It must be no warmer than ­18 °C. When plugging in the unit an acoustic alarm will activate. Push the yellow button to deactivate the alarm. Notice that the alarm must be activated again after 24 hours by pushing the yellow button. 7 GB Use Freezer The appliance is a four-star freezer approved for freezing and storing frozen items of food. ages as possible to prevent the surfaces of the items from drying out. Items to be frozen should be placed in the freezing compartment or evenly distributed along the inner walls of the freezer. Always remember to write the date, content and quantity on the packages before placing them in the freezer. A thin layer of frost or ice does not affect freezer performance, but the thicker the layer, the higher the energy consumption. Small amounts of loose frost can be removed using a plastic scraper. Never use electrical apparatus or sharp implements as these may damage the inside of the appliance. When the layer of frost and ice exceeds 4-5 mm the freezer should be completely defrosted. It is recommended that defrosting be performed when there are no or only a few items stored in the freezer. Press the Super Freeze button 4-5 hours before defrosting. This lowers the temperature of the items stored to approx. ­25 °C, thus prolonging the length of time they remain frozen after having been removed from the freezer (see step 3 below). Place them in a refrigerator or wrap them up to keep them as cold as possible. Position the partition under the defrost water drain. Place a bowl of hot (but not boiling) water in the freezer, close the lid and wait approx. [. . . ] 7 Advise for minimising the energy consumption The lower ambient temperature the lower energy consumption. The lower temperature inside the unit the higher energy consumption. Recommended temperature -18°C Defrost when the ice build-up is more than 5 mm thick. Do not open the lid more than necessary. [. . . ]