User manual SMITH CORONA OFFICE2000CHAP4

[. . . ] -- Quickly moves cursor to the left margin. -- Quickly moves cursor to the space following the last Adv then character displayed on the line. Code + Code + -- Shows next approximately 38 characters of text. -- Shows prior approximately 38 characters of text. Code + -- Moves typing position down equal to your line setting (i. e. , if you are double spacing text, key moves typing position down two lines). The line prints up to that point then moves the paper up. [. . . ] The carrier moves to the center of the margins. A beep is heard, and the display prompts: Auto Center @ and indicates the print hammer/cursor position. 2. Type the text to be centered. As you type, the text appears on the display. If a mistake is made, use Correct and WordEraser. Text prints and centers automatically between current margins. Press Return again to deactivate Auto Center and move the carriage to the left margin. NOTE: When Auto Center is activated, the Settings feature is not functional. Return 3. Reloc 4. 4-4 -- Line Mode Smith Corona Corporation Indented Paragraph To indent a paragraph, set "temporary left margins, " so text is automatically indented after carriage returns. The example below shows a paragraph which has been indented five spaces. National Accounting Seminar Marvelous Paper Products will participate in the National Accounting Seminar. We will focus on our new computerized accounting program. Those attending will include one Sales Account Executive from each of our Sales Districts, two System Consultants and two Field Service Technicians. Details will follow. Setting Indent 1. Tab or space to the desired indent location. When Auto Return is active or when the Return is pressed, the print hammer returns to the indented position. Press Code + Indent (6) to deactivate Indent. Text types, and the paper advances one line and returns to the original margin. The Status Line prompts: Indent OFF. Code + ¢~ 6 Changing Settings You can change the end of page setting, line spacing, impression control, pitch and number of lines displayed in Line Mode. To change settings, press Code + Settings (7). New settings will replace any existing settings. Settings are saved with the file, so you will not need to update these settings each time you recall and print an existing file. (See "Page Layout. ") NOTE: If you change pitch, remember to change the printwheel. Settings Code &[ + 7 Smith Corona Corporation Line Mode -- 4-5 Corrections Typing errors can be corrected both before and after a line is printed. However, three line correction memory is not active in Line Mode. When an error has been printed, you must use the Off-Line and Forward Correct features. Corrections on the Display You can correct characters on the display before they are printed by typing over the error, inserting additional text, or using the Correct, WordEraser, and LineEraser keys. Position Cursor Insert Code Inserting Text 1. [. . . ] Move the Mode Selector to Type Mode, if not already there. Position the print hammer on the incorrect character using the cursor keys, Spacebar, Return, and Back Space. Do not use the platen knob to position the print hammer. One beep is heard, and the display prompts: Manual Correct. [. . . ]