User manual SNAKEBYTE WII STARTER PACK XS

[. . . ] How to sync in One Time Mode: Press "HOME" on the controller that is synchronised permanently with the console. Select "WII REMOTE SETTINGS" in the upcoming menu, followed by "RECONNECT" Press "1" and "2" simultaneously on the Remote XS Controller which you want to sync with the Wii console in One Time Mode Repeat the above steps for each controller you would like to temporarily sync with your Wii console. The order in which controllers are synced represents the player numbers in multi-player games. Please be aware of the fact that the temporary synchronisation will be erased once the Wii is turned off and that the Standard Mode settings of the respective Remote XS Controller will then be reactivated. [. . . ] My Remote XS Controller's pointer moves erratically on the screen, regular game control is not possible. please take care that the sensor bar's position matches the console's setting. Further more you should make sure that there are no interferences between the Remote XS Controller's wireless Bluetooth connection and other wireless devices operating in the 2. Ideally no devices operating in the same room as the Wii console and Remote XS controller should emit radio waves that could potentially interfere with the Remote XS' signal transfer. Use the Remote XS Controller from the optimal operating distance of three metres and make sure there are no objects between controller and sensor bar that could influence the signal transfer. Avoid insolation and other intense light sources behind the TV set and sensor bar in order to maintain the optimal detection of the sensor bar's infrared LED by the Remote XS Controller's camera. Other sources of infrared light such as candles also cause incorrect detection, avoid placing such light sources within the Remote XS Controller's camera range. Further more pay attention to the sensor bar's correct sensitivity setting in your Wii console's option menu. In case the problem still persists, please restart your Wii console and sync your Remote XS Controller newly. Make sure the batteries in use are not too weak and replace them with fresh ones if required. In many cases pointing the Remote XS Controller off-screen for a few seconds solves the problem. Turn off your Wii console and turn it on again immediately. Make sure your main controller is synced with the console and the Motion XS Controller plug is firmly attached to the controller's Extension Port. My game seems to receive input signals although I do not even touch the Motion XS Controller. Turn off your Wii console and turn it on again immediately, this time making sure the analogue thumbstick of the Motion XS Controller remains in its neutral position during startup. You may also reset the thumbstick by making sure it rests in its neutral position and simultaneously pushing and holding A, B, Plus & Minus on the main controller it is connected with. Keep the buttons pushed for at least three seconds. My XS Controllers are incompatible with certain accessories Unfortunately compatibility with 3rd party accessories can not be guaranteed. This especially refers to light guns, sports packs and the like. Further more incompatibilities with Nintendo accessories may also occur due to differences in regard to button layout and/or shape. [. . . ] Your Remote XS Controller needs two AA batteries to operate. it is highly recommended to use quality Alkaline batteries for maximum operating time. (You may also use rechargeable NiMH batteries though the actual operating time of the We issue a guarantee of two years after purchase of the snakebyte XS Wireless Pack. Therefore, please preserve your invoice, e. [. . . ]