User manual SNOOPER STOPSLEEP

[. . . ] Get the most out of StopSleep by taking a few minutes to read this guide. An example of Electrodermal activity as user moves from an ‘active’ state to ‘microsleep’ and then ‘sleep. € 14 15 ENGLISH First time use To familiarize yourself with the StopSleep alerts, we advise you to test it in an non-dangerous environment such as at home at night watching television, or even going to bed.  This will allow you to differentiate between the two types of alerts: WARNING! [. . . ] 16 Understanding StopSleep alarms If your brain activity drops under a certain level, StopSleep will alert you. There are 2 levels of alerts: Turning Off and charging Turn StopSleep off by pressing the on/off button for 3 seconds. The LED will flash green followed by a deep tone. Connect either the home or vehicle charger supplied with StopSleep to the micro USB socket on the side of the unit. The LED will flash red every 5 seconds to confirm that it is charging correctly. The LED will turn from red to green once the battery is fully charged. Vibration Your concentration has dropped slightly even though you may not necessarily have noticed. Loud Beep + Vibration Your concentration and awareness has dropped significantly. Please note: StopSleep must be switched off when charging. If you attempt to charge StopSleep whilst powered on, it will beep every 2 minutes. If the battery has been completely discharged it is advisable to re-charge it using the AC adaptor. If the battery has been completely discharged, it could take up to 15 minutes before you see the red LED begin to flash indicating that it is charging correctly. Please Note: • StopSleep can alert even when you are not feeling obviously tired or drowsy. This could be due to a number of reasons. € Your level of attention or concentration can drop imperceptibly without you necessarily noticing. If your brain activity remains constant for a long time StopSleep might alert you to check your reaction time (on a long drive for example); • A big change in temperature can also trigger an alert (due to the sweat from your skin suddenly changing). 18 User Recommendations StopSleep has been designed to alert in case of drowsiness and drops in concentration and awareness. StopSleep should not be used as substitute for driving with due care and attention. The user is responsible for paying full attention to road conditions and under no circumstances should StopSleep be used to attempt to keep the user awake when feeling over-tired or too tired to drive safely. When driving always take regular breaks and always take a break at the first signs of fatigue or a drop in concentration. [. . . ] You will also find information on the return policy and procedure should you encounter a problem with StopSleep. 20 IN USE 3 sec 2 sec 1 min 2 min SWITCHING OFF Press the ON/OFF button for 3 seconds. Everything is ok Device switched off Skin not detected / device removed ENGLISH ALERTES WARNING!= Your attention has dropped significantly Low battery, the device will need charging soon Very low battery Battery flat, device will switch off 22 CHARGING STOPSLEEP StopSleep must be switched off while charging. [. . . ]