User manual SOLAC AB2650

[. . . ] The appliance should be switched off before it is plugged in or unplugged. â· Do not pull on or hang the appliance from the cord. Always unplug the appliance by pulling on the plug and never on the cord. â· Take care that the cord does not come into contact with sharp edges or hot surfaces. [. . . ] 2 Fit the flexible hose (7), placing the fitting (6) in the bag compartment opening (5), until you hear a click. To remove the hose, press the detach latches (8), turn and pull on the fitting. 3 Prepare the accessories that correspond to the surface you desire to clean. The attachments can be placed directly on the flexible hose (7) or, for out-of-reach places, the telescopic metallic tube (11) can be used. â· The suction brush (13) on these models can be used for all types of floors, carpets and rugs. We recommend cleaning hard floors, wood and parquet with the fibre brush enabled, and cleaning carpets and rugs with the fibre brush retracted. â· This model is supplied with a vacuum nozzle for narrow places, grooves and corners (15) that can be placed directly on the flexible hose (7) or the telescopic metal tube (11). â· The length of the telescopic tube (11) can be changed by moving the adjustment button (12) while moving both parts of the telescopic tube. 4 Pull out the cord (2) to the yellow mark (ideal length). If necessary, the cord can be pulled out to the red mark, but not any further. 5 Place the operating and regulating knob (16) at the MIN position and plug into the mains. 6 Switch the vacuum cleaner on by pressing the control knob (16) and regulate the motor power by turning the knob (do not press the kob, because this will switch off the vacuum cleaner). Notice that the knob (16) has both the on/off function (by pressing) and the motor power regulating function (by turning). 7 Suction power can also be adjusted by opening or closing the mechanical power regulator on the handle (10). 8 When finished, switch the appliance off by pressing the ON/OFF button (16). unplug it and press the button (18) on the handle to wind up the cord. Hold the cord plug in your hand to prevent it from banging against the vacuum cleaner housing. 9 The handle (18) can be used to carry the vacuum cleaner. The indicator (17) is completely red, a new paper bag must be installed in the vacuum cleaner. This indicator may show red if something is stuck in the flexible hose or in an attachment. [. . . ] This will rule out that poor placing of the filter or of the dust-bag, or tears or leaks in the bag obstruct the appliance and reduce suction capacity. 1 Remove the cover of the outlet filter by pressing on the opening button (27), (fig. 2 Separate the filter from the cover (fig. 3 Insert the new filter in the cover and place the cover with the filter in its place (fig. [. . . ]