User manual SOLAC AC SP7149

[. . . ] € This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instructions concerning use of the appliance by a person responsible for their safety. € Do not modify or repair the appliance in any way. If you detect any anomalies in the cord or any other part of the appliance, do not use it and take it to an authorised service centre. € If the power cord is damaged, it should be replaced by the manufacturer or by your after-sales service shop or similar qualified personnel to prevent possible hazards. [. . . ] € Never leave the appliance working on a wet surface or cloth. € When using the hairdryer in the bathroom, unplug it after use, since it is dangerous for the appliance to be near water, even when the hair dryer is switched off. € For extra protection we recommend installing a residual current device (RCD) not exceeding 30mA in the electrical circuit supplying the bathroom. IMPORTANT: When you want to dispose of the appliance, NEVER throw it in the rubbish bin. Take it to your nearest CLEAN POINT or the waste collection centre closest to your home for processing. You will thus be helping to take care of the environment. From overheating (if the air intake or outlet are blocked). If this happens, disconnect the device and wait for five minutes. Remove the cause of the obstruction, and switch the appliance back on. N Before plugging the appliance into the mains, make sure your hands and the appliance are completely dry. 1 If you want, attach the concentrator (8) or the diffuser (9). To do so, install the accessory on the air outlet (fig. 1) 2 Plug the appliance into the mains and set the airflow regulator (6) to the desired position: O-off, -minimum speed, -maximum speed (fig. 3 Set the temperature selector (5) to the desired position (fig. 3): 0- minimum heat, I- medium heat, II- maximum heat. 4 Follow the drying instructions according to the accessory used. 5 If you want air without heat, press the cold air button (7). 6 After using the dryer, set the airflow regulator (6) to the O position. N WARNING: do not use the appliance near water. N Be sure that the air inlet and outlet are not obstructed. [. . . ] ) Only clean the appliance when it is cold. Do not use any solvents, 4 Limpieza y Conservación ) Limpie el aparato sólo cuando esté frío. No utilice disolventes, 2 Description Main components Main body Power cord Air intake cover Air outlet 2 Descripción Partes principales Cuerpo principal Cable de conexión a la red Tapa de entrada de aire Salida de aire Mandos e indicadores 5 Selector de temperatura (3 posiciones) 6 Pulsador de puesta en marcha y regulador de caudal de aire (2 posiciones) detergentes ni productos abrasivos. 3 If the air intake becomes blocked, clean it. [. . . ]