User manual SOLAC CA4817

[. . . ] It is therefore normal for the electric pump to produce a little noise and vibration when it comes into operation. If the power lead is damaged, it should be replaced by the manufacturer or by an authorised after-sales service shop or similar qualified personnel to prevent possible risk. Switch with red pilot light Switch with coffee output warning light Switch with steam warning light Top cover Ground coffee receptacle (max. [. . . ] Never use more coffee than as indicated. Fill the reservoir with water, using the loading area (6). Make sure that the ends of the reservoir pipes are immersed in the water. 1) If you would like to use ground coffee, fill the coffee receptacle (5) with ground coffee. We recommend you not to use an extra-fine ground coffee. If you want your first coffee to have a higher temperature, set the filter holder in place without coffee and let one or two cups of hot water run out in order to warm the components of the coffee-maker. In addition, we recommend you to stand the cups to be used on the top cover (4) so that they are also warmed during this operation. Plug the coffee-maker into the mains and turn switch (1) to position I. Fit the filter you want to use, for 1 or 2 cups (13 or 14), in the filter holder (11). When you have finished, do not forget to turn off the steam switch (3). If you are going to use the supersteamer (8) continually to heat quite a lot of liquid (more than 100 ml approx. ), proceed as stated: once the steam has lost pressure (there is no force), close the supersteamer (7) control, press the coffee output switch (2) until a little liquid issues from the coffee outlet area. Then wait again until the steam switch pilot light (3) comes on. Repeat these steps as often as you consider necessary. When the coffee output switch pilot light (2) comes on, place the receptacle under the steamer (8). When you have the desired amount of hot water, release the coffee output switch (2) and close the steamer control (7). Do not use alcohol, solvents or abrasive products to clean the coffee-maker or tray, just a soft damp cloth. Every now and again, for more thorough cleaning of the steamer, proceed as follows: wait until the steamer cools down and unscrew its cylindrical part, in an anticlockwise direction. [. . . ] Every now and again, for more thorough cleaning of the steamer, proceed as follows: wait until the steamer cools down and unscrew its cylindrical part, in an anticlockwise direction. wipe the steamer spindle with a damp cloth and soap the cylindrical piece. Make sure that the little hole in the top of the steamer is clear before refitting the piece. [. . . ]