User manual SOLAC CO8500

[. . . ] It is dangerous to use it for any purpose other than the one indicated. Children must be supervised to ensure they do not play with the appliance. This appliance is not to be used by persons (or children) whose physical, sensorial or mental capacities are impaired, or who have no experience or knowledge, unless supervised or instructed in the use of the appliance by a person responsible for their safety. [. . . ] Remove all elements from the inside or outside of the appliance used for protection during transport or for sales promotions, such as paper or plastic bags, plastic sheets, cardboard and stickers. 1 Main body 2 Switch I (750 W) 3 Switch II (1250 W) 4 Fan switch 5 Temperature thermostat 6 Mains power cable 7 Plastic legs (2 units) 8 Wall brackets (4 units) 9 Screws for legs/lower wall bracket (4 units) 10 Nylon wall plugs (4 units) 11 Screws (4 units) For floor use: For wall use: 1 Fix the legs to the bottom of the appliance using the screws (9) provided (fig. Choose the place where the heater is to be installed carefully according to the instructions and in compliance with regulations. To avoid the new smell of the appliance when using it for the first time, switch it on and leave it operating for 2 hours at the highest temperature. Do not use the heater near a bath, shower or swimming pool. The appliance must be installed so that the switches, thermostat and power cable cannot be touched directly or indirectly by a person in the bath or shower. always use the appliance in a horizontal position. Keep the front of the appliance at least 90 cm from furnishings, inflammable materials, curtains, carpets, armchairs, etc. do not use the appliance on wet surfaces or outdoors. The appliance must be connected to a power socket with a suitable ground connection. When you want to dispose of the appliance, NEVER throw it in the rubbish bin. Take it to the CLEAN POINT or waste collection centre closest to your home for processing. You will thus be helping to take care of the environment. The appliance should never be covered with clothes, containers or any other objects, nor should it be placed under a wardrobe or anything else that could obstruct the hot air flow. 4 Fix the lower brackets (8) to the heater using the screws provided (9) (fig. 6 With the heater in place, mark on the wall the position of the hole to be drilled for fixing the lower bracket. 7 Drill the hole into the wall and insert the supplied wall plug (if necessary, remove the heater so you can work without obstruction, replacing it when you have finished). 8 Fix the lower bracket (8) to the wall using the plug and screws provided (fig. [. . . ] If the safety device switches the device off repeatedly, please contact your nearest after-sales service. Use a slightly < Never submerge in water or some other liquid or place it under the tap. Do not use abrasive products or those incompatible with epoxy paint: this may discolour the apparatus. [. . . ]