User manual SOLAC CP7318

[. . . ] â· To cut the HAIR EVENLY, allow the clipper ADVANCE SMOOTHLY through the hair. It is better to cut a little than too much. We recommend that you make a note of the cutting level selected each time, so that you can repeat the same hairstyle on other occasions if you wish. [. . . ] â· Never leave the charger working on a wet surface or cloth. â· If you use the appliance without the telescopic comb, be careful not to injure your skin. â· If the blade or the telescopic comb show signs of breakage or damage, stop using the appliance and repair it before using it again. â· The blades must be clean and have no traces of hair to work properly. Therefore, use the attached brush (6) to clean them before and after use. Hereby disclaims all liability for injuries or damage that could be caused to persons, animals or property due to the failure to heed with these warnings. 1 Check that the clipper is clean and that there are no traces of hair between the blades, as this could prevent it from working properly. 2 Sit the person whose hair you are going to cut so that their head is level with your eyes. 3 Untangle the hair and comb it in its natural direction. The first time you use the device, we recommend you start with the selector (4) in position 6 or 7. When you have become familiar with the hair clipper, adjust the comb to the cutting length desired. Hold the clipper against the scalp with the blade teeth facing upwards. Keep the clipper resting against your scalp and slide it along smoothly. 2 Gradually raise the head of the clipper towards you. Continue cutting on the back part of the head from the base of the neck to above the ears (Fig. For short hair Back of the neck 5 To achieve a straight line at the sideburns and around the ears, remove the telescopic comb, rest the clippers at right angles to the head, in the inverted position with the blades in contact with the skin, and move them downwards (Fig. Place the selector (4) in position 7 and carefully push outwards until it goes past the end (Fig. To replace the telescopic comb on the hair clipper, fit the guides correctly into the guide rails and push downwards until you go past the end (Fig. [. . . ] To discharge them, turn the appliance on without the cord until it stops running, then put the switch (3) in the "OFF" position. then recharge the batteries as explained above. When you decide to discard the device, first remove the battery. [. . . ]