User manual SOLAC CP7395

[. . . ] Switch off the appliance when not in use, even if only for a moment. Check the condition of the cord from time to time. Do not use it if the guide combs (6) are damaged or broken or if any blade teeth are missing (4 and 5). Never use any accessory not recommended by Solac, as they could damage the appliance. [. . . ] During the charging operation, the pilot light (3) lights up red, and changes to green when the appliance has finished charging. The first time you charge the personal grooming appliance (1), it will take approximately 24 hours. The appliance can only be charged when the switch is in the `0' position (Fig. 3) · When charging or recharging the appliance, the room temperature should not be below 15ºC or above 35ºC, as this may affect battery life. Seven hours' charging time when recharging the appliance will give about 75 minutes' operating time. If the appliance is not used for a month, recharge it fully before use. For optimum battery life, use the appliance until the battery is completely run down and then recharge it fully. Two accessories can be attached to these blades (Fig. This comb allows you to adapt the cutting length according to your needs. Level 10: 10 mm B) Shaving head (10): for comfortable shaving of facial areas, fixing the edge of the beard, goatee, etc. and for finishing touches at the back of the neck. C) Head for nostrils and ears (9): for cutting ear and nostril hair. Check that the appliance is clean and that there are no traces of hair between the blades, as this could prevent it from working properly. Use the comb to comb the hair to be cut (16) Press the "turbo" button (4) on the rear of the appliance (1) and keep it pressed while you want to use this speed. To remove the blades (5 and 6) from the appliance (1), push the blades upwards with your thumb from the front (Fig. Next, install the required guide comb according to the desired cutting length (Fig. We recommend that you start off with one of the longest positions and change it as required. Install the shaving head (10), inserting the hook of the head in the case of the appliance. You can use this accessory to go over the contour of the beard and achieve an even result and a well-defined beard. Next, install the required guide comb according to the desired cutting length (Fig. [. . . ] In any case, we recommend that you lubricate it at least once a month. We recommend that you lubricate the detail blade (6) before and after each use Perform this operation every three months. When lubricating the blades, remove the guide combs (7) and the protector (8) if they are installed. Used batteries should not be disposed of with the normal refuse. [. . . ]