User manual SOLAC ECOGENIC

[. . . ] Before plugging the appliance into the mains, check that the indicated voltage is the same as in your home. Turn off and unplug the appliance before dismantling or assembling parts and prior to any maintenance or cleaning operation. Always unplug the appliance by pulling on the plug, and not the cord. Make sure the cord does not come into contact with sharp edges or hot surfaces. [. . . ] ) After cleaning, the battery temperature may be high and therefore the charge time may Disconnect it when it has finished charging. Do not store or charge the appliance near radiators or other heat sources, or exposed to direct sunlight. Do not charge the appliance in dirty or damp places. The room temperature should be between 15ºC and 35ºC. Every few months, allow the batteries to drain completely and then recharge them. To discharge them, use the appliance in cordless mode until it stops, with the charging station switched off. When storing the appliance for a long period of time, we recommend you fully charge the battery and then remove it for storage in a cool, dry place. This appliance is intended for daily floor maintenance, avoiding the accumulation of dirt and appearance of fluff. Never vacuum live ash, splinters or other sharp objects, or liquids. Completely remove all the elements used for transportation and packaging. Do not use the robot vacuum cleaner between small tables, chairs or very small spaces, as this could damage the appliance. The robot vacuum cleaner uses cleaning settings to effectively clean the whole floor: Spiral movement for more intense cleaning where dirt has been detected, wall following for cleaning the perimeter of the room and room-crossing to ensure a full clean. The robot vacuum cleaner will take approximately 45 minutes to clean an average-sized room, passing over the same area several times to ensure the whole surface is cleaned. Charge button: Lights up when pressed, turns off when the robot connects to the charging station. Ultra-violet lamp: Lights up when pressed, the disinfection lamp will operate while the robot is cleaning. 1 Remove all objects that could break or damage the robot vacuum from the floor (e. CHARGING THE ROBOT VACUUM") 6 If you want to use the robot vacuum in automatic mode, programme its operation using the remote control. The robot vacuum will then start to operate, following its cleaning patterns. , If you wish, you can control its movements or functions using the remote control buttons , Press the UV key, if you want to sterilise the front area. This function is particularly recommended for people suffering from allergies and for homes with pets, as it sterilises the floor against viruses and bacteria. 8 Press the button again to pause the cleaning process. 9 If you do not want a programmed weekly clean, turn off the appliance after cleaning. [. . . ] Return the clean filter, or new filter if necessary, to its holder. Turn the vacuum module round, release the two tabs and remove the lid. Clean the interior of the bin using the cleaning brush (6) (fig. Use the cleaning brush to clean the vacuum module (15) and the air intake and outlet unit (fig. [. . . ]