User manual SOLAC SF5051

[. . . ] Make sure the cord does not come into contact with sharp edges or hot surfaces. Do not leave the cord hanging over the edge of a table or worktop, to prevent children from pulling it and causing the appliance to fall. If the power cord is damaged, it should be replaced by the manufacturer or by your after-sales service shop or similar qualified personnel to prevent possible hazards. Remove all elements from the inside or outside of the appliance used for protection during transport or for sales promotions, such as paper or plastic bags, plastic sheets, cardboard and stickers. [. . . ] The iron must not be used if it has been dropped, or if there is any crack or leak in the water tank. If you observe any of these problems, take the iron to a T. Do not leave the appliance unattended when switched on. The soleplate can get very hot when the appliance is in use. During operation, do not touch the soleplate and only hold the iron by its handle, and ensure the cord does not come into contact with the soleplate CAUTION!When you want to dispose of the appliance, NEVER throw it in the rubbish bin. Take it to the CLEAN POINT or waste collection centre closest to your home for processing. You will thus be helping to take care of the environment. Main body Power cord Metal soleplate Spray outlet Water filler opening Water tank 7 8 9 10 11 12* Spray button Supersteam button Temperature selector Steam/Self-clean selector Temperature pilot light Water beaker (only model PV2210) , Due to the high levels of mains water hardness in most areas, Solac recommends that you always use demineralised water for ironing. In this way, you will guarantee that your iron remains in optimal condition for a longer period of time. , If, for any reason, you cannot find demineralised water, please ensure you use water with a low mineral content (soft water), or filter tap water using a water filter. When the selected temperature is reached, the pilot light will go out (11). 1 When the pilot light (11) goes out, indicating that the desired temperature has been reached, rotate the steam selector (10) until the desired steam flow is obtained (fig. ) When you finish ironing, always empty the water from the tank. 2 Unplug the plug from the mains 3 Open the water filler opening (5) and place the iron face down over the sink, gently shaking it to completely empty the tank. 4 Wait until the iron is completely cold and store it in the vertical position in a safe place. , For professional ironing results, we recommend you steam iron garments first and then ) If you want more steam while ironing, press the button (8) two or three times, aim the Supersteam at the desired area of the garment and pass the iron soleplate over it to dry it. thus is useful for eliminating wrinkles. ) The supersteam may not be released on the first occasions. ) This allows you to remove creases from delicate garments without having to put them 2 Place the garment on a hanger, well away from other garments, people, animals, etc. N Do not discharge steam onto a garment hanging in the wardrobe or on a person. 4 Bring the iron close to the garment, in the vertical position, (between 15 and 30 cm) and press the supersteam button (8) once only. [. . . ] The iron incorporates an anti-drip system that prevents the iron from dripping, even when it is switched off. ) Clean the appliance after using it for the first time, immediately after each use and after en a long time without use. 1 To clean the external part of your iron, use a cloth dampened with soapy water. , Do not use solvents or abrasive products to clean your iron, as these could damage some of the plastic parts and/or remove some of the marks 2 Store your iron in a vertical position, coiling the cord around the base and pressing the cable into the fixing clip. [. . . ]