User manual SOLAC VT8820

[. . . ] Read these instructions carefully before using your appliance, and keep them for future reference. Remove all elements used for protection during transport or for sales promotions, such as paper or plastic bags, plastic sheets, cardboard and stickers from inside or outside the appliance. Do not introduce any object inside the appliance. [. . . ] If the power cable is damaged, it should be replaced by the manufacturer or by your after-sales service shop or similar qualified personnel to prevent possible hazards. Before starting the appliance, check that it is on a stable surface and is in its normal operating position (on its base). : When you want to dispose of the appliance, NEVER throw it in the rubbish. Take it to your nearest RECYCLING POINT or waste collection centre for treatment. If you do that, you will be helping to look after the environment. Ring Rear grille Connecting ring Fixing plate Fan body Handle Oscillation button Stop switch Low power switch Medium power switch High power switch Turn-off timer Telescopic tube Height adjustment ring Fixing screw Base Telescopic tube base Shaft protector Introduce the base of the telescopic tube (20) into the base so that its flanges enter the spaces in the base (19). To join the pieces, turn the tube (2) clockwise as far as it will go. Fit the fan body (8) on the tube (16) and attach it by unscrewing the fixing screw (18) slightly so that the telescopic tube (16) penetrates the body of the fan ), then tighten the fixing screw again and check that both pieces are attached. Fit the rear grille (5) over the shaft (8) so that the projections on the motor shaft coincide with the orifices on the rear grille (5)Fig 1. Insert the blades (3) so that the slits on their upper parts meet the projections on the fan body (8). fig 3 · Fix the blades turning the hood (2) anticlockwise. Fit the front grille (1), inserting the rear grille in the guide in the connecting ring (6). The fixing plate (7) must appear to be centred in the lower section. Close the fixing plate (7) and tighten the safety screw. [. . . ] Do not use solvents or abrasive cleaners to clean the device, since they could damage its plastic parts. When the appliance is not in use it should be kept in a damp-proof location. Îndeprtai toate elementele care au fost folosite pentru protejarea aparatului pe durata transportului sau pentru promoii de vânzare, cum ar fi pungi de plastic sau de hârtie, foi de plastic, cartoane sau etichete, care sunt prezente atât în interiorul aparatului cât i pe exteriorul acestuia. [. . . ]