User manual SOMFY 5012940

[. . . ] Pushing the emergency stop button stops the gate entirely. It may be equipped with other safety devices, such as photoelectric cells. Any detection during closure causes stopping then reopening (total or partial, depending on parameter A1). [. . . ] Any detection during opening causes stopping then closue (total or partial, depending on parameter A0). Parameter settings activate the following safety devices: - Detection before opening the gate excludes all movement. - Detection when closing the gate stops the gate and reopens it. Correct operation of the safety devices can be checked (parameter A2 to A6) at the end of each opening/closing cycle. A fault on a safety device prohibits any movement. When the gate is in movement, 2 outputs control the following devices: Control Area lighting Orange light Contact Dry contact Vmax: 230Vac - Pmax: 150Va Output 2 x 15 w (sequence control) According to the parameter settings (parameter Po), the 24V control box has several operating modes: Modes Automatic/Blockage/Senquenced+timed: Compulsory installation of safety accessorie. The gate automatically closes once closing time has expired. Blockage After the gate is opened, passage in front of the closing security cells closes the gate after a SEC. Emergency stop and safety devices · Without emergency stop with safety devices · Emergency stop without safety devices · Without emergency stop without safety devices · Only modify parameters when the gate is stopped and closed. After parameter setting, check the good fonctionning of safety accessories. To be taken into account, all modified values must be validated by pressing this key. Auto learning is used to measure the stroke, the opening angles of the leaves, to assign the speeds and offsets so that the dor can operate after auto learning. Need (except value 05 which is prohibited) and the auto learning `P3' to `01'. Generate an opening command via the outer command or the radio (after programming it). The door leaf(ves) should open and check the covering leaf (cable on M1) starts first, otherwise, · When the display indicates ` H1', generate a new command to close. All these parameters may be modified after learning to make the door movement more precise. [. . . ] The door leaf(ves) should open and check the covering leaf (cable on M1) starts first, otherwise, · When the display indicates ` H1', generate a new command to close. All these parameters may be modified after learning to make the door movement more precise. 2 · For very fragile doors, it is possible to perform auto learning at a reduced torque by reducing the value of parameters `P4 and P5' immediately after setting the auto learning parameter ` P3' to `01' and before executing the opening command. [. . . ]