User manual SONY ADP-MAA

[. . . ] Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation dimensions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . General safety information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] (1) Temperature controller (2) Cool-Plus switch Fig. 3 4 Putting into operation 4. 1 Transporting the appliance CAUTION Risk of injury and danger of damage as a result of incorrect transport!u Transport the appliance in a packed condition. u Do not transport the appliance without assistance. NOTICE Risk of damage due to condensate!u Do not install the appliance directly alongside a further refrigerator/freezer. q In the event that the appliance is damaged, contact the q The floor at the site must be flat and level. q Do not install the appliance in a location where it is exposed supplier immediately before connecting to the mains. 4. 2 Installing the appliance WARNING Fire hazard due to dampness!If live parts or the mains lead become damp this may cause short circuits. u The appliance is designed for use in enclosed areas. Do not operate the appliance outdoors or in areas where it is exposed to splash water or damp conditions. to direct radiation of the sun, next to a cooker, heater and similar. q Always stand the appliance backed directly to the wall using the enclosed wall spacers (see below). q The appliance may be moved only when it is empty. u Do not use extension cables or multiple socket outlets. The type of current (alternating current) and voltage at the installation site have to conform with the data on the type plate (see Appliance at a glance). Connect the appliance only with a properly installed socket outlet with earthing contact. The socket outlet must be fused with 10 A or higher. It must be easily accessible so that the appliance can be quickly disconnected from the supply in an emergency. It must be outside the area of the rear of the appliance. u Plug in the power plug. 5. 1. 3 Relocating the shelves The shelves have stops preventing them from being unintentionally pulled out. u Lift the shelf and draw it out forwards. u Insert shelf with the raised edge pointing upwards at the back. w The food does not freeze onto the rear wall. 4. 7 Switching on the appliance Put the appliance into operation about 2 hours before first loading food to be frozen. 3 (1) to the right, from the 0 setting to point 3. [. . . ] The power plug is not properly inserted in the wall socket. The fuse of the wall socket is not in order. Check fuse. 8 Decommissioning 8. 1 Switching off the appliance u Turn temperature control Fig. 3 (1) to 0. The compressor runs for a long time. [. . . ]