User manual SONY CDP-C910

[. . . ] Do not connect either wire to the earth terminal in the plug which is marked by the letter E or by the safety earth symbol Y or coloured green or green-and-yellow. Before operating the player, check that the operating voltage of the player is identical with your local power supply. The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. If you are not going to use the player for a long time, be sure to disconnect the player from the wall outlet. [. . . ] If the playback of the current disc ends, the player stops playing. If the disc is played in 1 DISC Repeat Play mode (see page 10), the current disc starts playing again. In Programme Play mode (see page 11), only the tracks on the current disc are played. Do not push the disc tray to close it in Step 5, as you may damage the player. You can quickly locate any track while playing a disc using the /± (AMS: Automatic Music Sensor) buttons or number buttons. You can also locate a specific point in a track while playing a disc. You can locate any disc before or while playing a disc. The next disc A specific disc directly A disc while checking the labels DISC SKIP while playing a disc DISC 1 ­ 5 DISC CHECK while the disc tray is open. The disc tray turns to show you each disc label. When the disc you want comes in front of you, press · to start playing. DISC CHECK before you start playing while the disc tray is closed. The indication appears while the player is "shuffling" the tracks. If a programme is already stored, the last step of the programme appears in the display. When you want to erase the whole programme, hold down CLEAR until "ALL CLr" appears in the display (see page 12). You can start Shuffle Play while playing When you want to programme the whole disc as one step, skip Step 3 and go to Step 4. Press the number buttons of the tracks you want to programme in the order you want. To programme the track numbered over 10, use the >10 button (see page 10). After one second If you've made a mistake Press CLEAR, then press the correct number button. Other discs Other tracks on the same disc Other tracks on other discs You can check your programme before or after you start playing. Each time you press this button, the display shows the track (the disc and track numbers) or the disc (the disc number and "AL" indication) of each step in the programmed order. After the last step in the programme, the display shows "End" and returns to the original display. If you check the order after you start playing, the display shows only the remaining steps. [. . . ] If you've made a mistake press the number button of the track. The track number and "On" appears in the display and the track will be restored. Removing tracks from a clip 1 Before you start playing, press one of the MUSIC Press or ± to select the track you want to remove from the clip. The player starts playing the next track in the clip. [. . . ]