User manual SONY CDP-CX53

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. This equipment is intended for home entertainment purposes only. [. . . ] Turn on the amplifier and select the CD player position. All discs in the player consecutively in the order of disc number. Only the one disc you have selected You can turn on the player by pressing I/u on the remote Z Turn the JOG dial until the disc number you want appears in the display to select the first disc (ALL DISCS) or the disc you want (1 DISC). When you turn off the player by pressing the I/u (standby mode) The player remembers the last playing disc and the play mode (Continuous, Shuffle (see page 12) or Program (see page 13)). When you turn on the player again, therefore, the player plays the same disc in the same play mode. Note that the player does not remember this information, if you turn off the player by pressing the power switch of the amplifier or receiver while the AC power cord is connected to the switched AC outlet of the amplifier or receiver. The selected disc is set to the playing position, and the player plays all the discs from the selected one (ALL DISCS) or all the tracks once (1 DISC). While playing a disc, the display shows the current disc number, track number, playing time of the track and the next disc number. Next disc number Playing time of the track Pause Resume playing after pause Go to the next disc Go back to the preceding disc Go to the next track Go back to the preceding track Stop playing and remove the disc Press ± Press Open the front cover, then push the JOG dial. You can specify the next disc to play while playing a disc in Continuous or 1 DISC Shuffle Play mode. While playing a disc, turn the JOG dial until the disc number you want appears in the display. Next disc number After the current disc is played, the next disc you have specified starts playing. If you want to skip to the next disc right away, push the JOG dial while playing the current disc. You can quickly locate any track while playing a disc using the /± (AMS: Automatic Music Sensor) buttons. You can also locate a specific point in a track while playing a disc. Turn the JOG dial until the disc number you want appears in the display. Example: To enter number 35 Press 3, then 5. You can play discs/tracks repeatedly in any play mode. The player repeats the discs/tracks as follows: When the disc is played in All tracks on all discs All tracks on the current disc The player does not repeat discs/tracks but keeps shuffling until you stop play whether or not you press REPEAT. The next or succeeding tracks the current or preceding tracks a specific track directly Z ± repeatedly until you find the track repeatedly until you find the track The number button of the track on the remote. When you locate a track with a number over 10, press >10 first, then press the 10's digit and 1's digit. ) (forward) or 0 (backward) and hold down until you find the point ) (forward) or 0 (backward) and hold down until you find the point during pause. [. . . ] After removing a disc from the disc slot, store the disc in its case. Place the player in a location with adequate ventilation to prevent heat build-up in the player. Do not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. Do not place the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. [. . . ]