User manual SONY CDP-CX100

[. . . ] ⷠDo not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. ⷠDo not place the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. The model and serial numbers are located at the rear of the unit. [. . . ] The display shows the total number of tracks, total playing time and music calendar. The track numbers in the music calendar disappear after they are played. Each time you press TIME while playing a disc, the display changes as shown in the chart below. Music calendar Total playing time Playing time and number of the current track Press Remaining time on the current track If the track number exceeds 68, "­ ­ . While in Shuffle Play mode ("SHUFFLE" appears in the display; see page 9), a one-second access time blank is added between each track. This increase is automatically added to the total playing time in the display. The information also appears when you press § OPEN/CLOSE to close the disc tray. You can quickly locate any track while playing a disc using the AMS (Automatic Music Sensor) on the player or number buttons on the remote. You can also locate a particular point in a track while playing a disc. When you directly locate a track numbered over 10 when using the remote (CDP-CX100 only) Press >10 first, then the corresponding number buttons. Example: To play track number 30 Press >10 first, then 3 and 10. example: To program the tracks 2 , 8 and 5. Press number buttons in the order 2, 8 and 5. Last programmed track Playing order When tracks, which aren't numerically consecutive on the disc, are programmed consecutively (i. After one second The program remains even after the Program Play ends when you press · , you can play the same program again. To select a track with a number over 10 Notes ⷠThe total playing time doesn't appear in the display when it exceeds 100 minutes. ⷠ"FULL" appears in the display when you try to add a track to a program which already contains 24 tracks. If you've made a mistake Press CLEAR, then press the correct track number. When tracks, which aren't numerically consecutive on the disc, are programmed consecutively (i. The program remains even after the Program Play ends When you press (, you can play the same program again. You can check the total playing time while programming using the remote (Program Edit) To select a track, press = or + and check the total playing time. Then press PROGRAM to confirm your selection. [. . . ] Press EDIT/TIME FADE before you start playing until EDIT appears and "A" in the indication flashes in the display. press 0 or ) to specify the tape length. Each time you press these buttons, the display changes as shown below, with the tape length of one side following each indication. When tracks, which aren't numerically consecutive on the disc, are programmed consecutively (i. [. . . ]