User manual SONY CDX-GT660UP

[. . . ] 2 Only use screws and fixing material supplied!A2 brackets (L) left and (R) right B2 base-plates with screws (M6 x 20) and double-sided self-adhesive tape C4 hexagonal bolts with washer (M5 x 10) D4 hexagonal nuts (M6) E4 tapping screws (5 x 12) F 12 round stickers for dust protection G4 dust protection stickers for setting shock absorber mechanisms (CHD 1002S only) GB REMOVING TRANSPORT SCREWS Fig. 3 1 2 3 4 Remove the three transport screws from the underside of the CD changer. Clean around the three holes on the CD changer. [. . . ] · The opening for the CD magazine must face upwards in case of vertical mounting (Fig. · The maximum inclination may not exceed 15° from the horizontal or vertical axis (Fig. 4 or 5) or from the 45° position (Fig. 6). 3 SHOCK ABSORBER ADJUSTMENT The CD changer is pre-set at the factory for horizontal mounting (Fig. If you mount the CD changer horizontally no adjustment is needed. In this case go to the next section "MOUNTING". If you mount the CD changer vertically, or at a 45° angle, (or if you later change the mounting angle) you must first change the shock absorber setting. · Change the position of the setting mechanisms at both sides of the CD changer using a screwdriver. · For vertical mounting, use position "V" (Fig. · For mounting at an angle of approx. 45°, use position "45°" (Fig. If your car radio does not already have a socket for the suitable connector, consult your dealer for an adapter cable. Connect the extension cable to the fly lead cable of the CD changer. 5 Reconnect the negative car battery terminal (Fig. Installation is now complete. 6 OPERATION FILLING THE MAGAZINE 1 GB 2 3 Pull the tab on the magazine's disc tray to remove one of the trays. Place the disc on the tray with its play surface facing up (label surface facing down). · Each tray can accommodate only one disc. · The CD changer will not function if the discs are placed with the wrong side facing upwards. Press the tab on the disc tray to store the tray back in the magazine. · Up to 6 or 10 discs can be loaded depending on version. INSERTING THE MAGAZINE 1 Open the sliding door. 2 3 4 Hold the magazine the correct way up with the narrow side facing the opening of the CD changer as shown. Gently push the magazine into the opening of the CD changer (until you hear a click). Close the sliding door to prevent dust and dirt from entering the CD changer. 1 2 3 TAKING OUT THE MAGAZINE 1 2 Fully open the sliding door. Close the sliding door. 3 4 7 OPERATION HANDLING DISCS · Do not drop discs. [. . . ] If fuse blows again, consult a Service Agency. Pay attention to the printing on the magazine. Load disc with play side facing upwards. Insert disc without scratches or which is not warped. [. . . ]