User manual SONY CFD-460

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. [. . . ] To check the order of tracks before play Press DISPLAY·ENTER MEM. Every time you press the button, the track number appears in the programed order. To change the current program Press p once if the CD is stopped and twice if the CD is playing. Then create a new program following the programing procedure. The CD Player 17 The CD Player Enjoying sound effects (LOOP/FLASH) You can repeat part of a CD (LOOP) and can "flash" the CD sound (FLASH) during playback. LOOP FLASH 1 2 Play a CD. Press and hold LOOP or FLASH at the point you want to start the function. To repeat a selected part of a CD "flash" the CD sound Press and hold LOOP FLASH To cancel the LOOP or FLASH function Release the button. The player returns to normal play. 18 The CD Player The Radio Presetting radio stations You can store radio stations into the player's memory. You can preset up to 20 radio stations, 10 for each band in any order. PRESET ­ BAND PRESET + DISPLAY ENTER MEM The Radio On the remote 1 Press BAND to select the band. 2 Set the frequency to the station you want. 3 Hold down the number buttons that you want to preset the new station on for 2 seconds. The frequency digits flash in the display and the station is stored into the player's memory. 1 2 3 4 5 Press BAND until the band you want appears in the display. Set the frequency to the station you want. To return to normal sound, press the button again. Setting Up 27 Additional Information Precautions On safety · As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Refer servicing to qualified personnel only. · Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. On power sources · For AC operation, use the supplied AC power cord; do not use any other type. · The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. · Unplug the player from the wall outlet when it is not to be used for an extended period of time. · For battery operation, use six size D (R20) batteries. · When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. · The nameplate indicating operating voltage, power consumption, etc. On placement · Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. · Do not place the player on an inclined or unstable place. [. . . ] The REC r button does not function/The tape does not play. The tape does not erase completely. Remedy · Close the tape compartment securely. · Make sure the safety tab on the cassette is in place. · Make sure "TAPE" appears in the display. [. . . ]