User manual SONY D-EJ711

[. . . ] About the area code The area code of the location in which you purchased the CD player is shown on upper left of the bar code label on the package. For accessories supplied with your CD player, check the area code of your model and see "Accessories (supplied/optional). To prevent fire or shock hazard, do not expose the unit to rain or moisture. CAUTION The use of optical instruments with this product will increase eye hazard. [. . . ] (HOLD) You can lock the controls on your CD player to prevent accidental button presses. Flashes when the volume is turned up and beyond a certain level. You can use the HOLD function with both the CD player and remote control. You can still operate your CD player using the remote control when HOLD on the remote control is set to off. Turning off the operation beep sound You can turn off the beep sound that is heard from your headphones/earphones when you operate your CD player. Remove the power source (AC power adaptor, rechargeable batteries or dry batteries) from the CD player. Connect the power source while pressing x/CHG on the CD player or x on the remote control. To turn on the beep sound Remove the power source and then connect the power source without pressing x/CHG or x. B Connecting your CD player You can listen to CDs through a stereo system and record CDs on a cassette tape and a MiniDisc. for details , see the instruction manual that comes with the connected device. Be sure to turn off all connected devices before making connections. Before you play a CD, turn down the volume of the connected device to avoid damaging the connected speakers. â· Use the AC power adaptor for recording. If you use the rechargeable batteries or dry batteries as a power source, batteries may become completely depleted during recording. â· Adjust the volume properly on the connected device so that the sound will not be distorted. You cannot adjust the volume of the headphones/earphones on the CD player or the remote control. When using the optical digital connecting cord To record a CD on a MiniDisc, DAT, etc. , make sure that the CD player is in pause before operating the recording procedures. About the SOUND function when using the connecting cord See the following table for valid functions according to the types of connecting cord: * Functions only on the output sound from the i/REMOTE jack; does not function on the output sound from the LINE OUT (OPTICAL) jack. About Joint Text (CD text copying function) The Joint Text function allows you to copy the disc and track names that are on a CD containing CD text information. By connecting a Sony MD Walkman (MZ-R90/ R91), which supports Joint Text, to this CD player, you can copy the CD text onto an MD during recording. You must use an optical digital connecting cable (POC-5B or other model, not supplied) and the RK-TXT1 CD text connecting cable (not supplied) to make the connections. [. . . ] â· Do not put any foreign objects in the DC IN 4. C Check that you are using alkaline batteries and not manganese batteries. (page 20) c Use only the AC power adaptor or car battery cord in "Accessories (supplied/optional). " (page 25) c Remove all power sources, then insert the batteries or connect the AC power adaptor again. [. . . ]