User manual SONY DCR-TRV140

[. . . ] 3-072-317-14 (1) Digital Video Camera Recorder Video Camera Recorder Operating Instructions Before operating the unit, please read this manual thoroughly, and retain it for future reference. Owner's Record The model and serial numbers are located on the bottom. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. Model No. ACSerial No. DCR-TRV140 DCR-TRV140 CCD-TRV107/TRV108/TRV308/TRV408/ TRV608 2002 Sony Corporation Welcome! Congratulations on your purchase of this Sony Digital Handycam camcorder/Handycam VisionTM . [. . . ] Note If you set the background color to FADE in Step 3, the picture may not appear properly depending on the connected VCR. You cannot record on the VCR when: The tape has run out. The write-protect tab is set to expose the red mark. The button used to cancel recording pause is not correct. NOT READY appears on the screen when: START is not carried out. 82 Dubbing only desired scenes Digital program editing DCR-TRV140 only You can duplicate selected scenes (programs) for editing onto a tape without operating the VCR. Unwanted scene Unwanted scene Switch the order Editing Before operating the Digital program editing function Step 1 Connecting the VCR (p. Step 2 Setting the VCR for operation (p. Step 3 Adjusting the synchronization of the VCR (p. When you dub using the same VCR again, you can skip steps 2 and 3. Using the Digital program editing function Operation 1 Making the program (p. Operation 2 Performing Digital program editing (dubbing a tape) (p. 91). Step 1: Connecting the VCR You can connect both the A/V connecting cable and the i. LINK cable (DV connecting cable). When you use the A/V connecting cable, connect the devices as illustrated in page 73. When you use the i. LINK cable (DV connecting cable), connect the devices as illustrated in page 74. 83 Dubbing only desired scenes Digital program editing Step 2: Setting the VCR to operate with the A/V connecting cable To edit using the VCR, send the control signal by infrared rays to the remote sensor on the VCR. When you connect using the A/V connecting cable supplied, follow steps (1) to (4) below, to send the control signal correctly. (1) Set the IR SETUP code 1 Set the POWER switch to VCR on your camcorder. 2 Turn the power of the connected VCR on, then set the input selector to LINE. When you connect a video camera recorder, set its power switch to VCR/ VTR. 4 Turn the SEL/PUSH EXEC dial to select , then press the dial. 5 Turn the SEL/PUSH EXEC dial to select VIDEO EDIT, then press the dial. 6 Turn the SEL/PUSH EXEC dial to select EDIT SET, then press the dial. 7 Turn the SEL/PUSH EXEC dial to select CONTROL, then press the dial. 8 Turn the SEL/PUSH EXEC dial to select IR, then press the dial. 9 Turn the SEL/PUSH EXEC dial to select IR SETUP, then press the dial. [. . . ] 109 OVERLAP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 Photo scan . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 71 Photo search . . . . . . . . . . . . . . . . . . . . . . . . . 46, 64 Picture search . . . . . . . . . . . . . . . . . . . . . . . [. . . ]