User manual SONY HCD-H50 SERVICE MANUAL

[. . . ] * For using with the optional MD deck MDS-MX101 ** For using with the optional cassette deck TC-TX101 This system is equipped with Dolby Noise Reduction* system. * DOLBY noise reduction manufactured under license from DolbyLaboratories Licensing Corporation. The instructions in this manual are for the tuner CD player HCD-H50, the optional MiniDisc deck MDS-MX101 and the optional stereo cassette deck TC-TX101. The instructions of the MiniDisc deck and the stereo cassette deck are only for the customers who purchased MDS-MX101 and TC-TX101. [. . . ] Marking track numbers at a specific point while recording ⭠Level Syncro recording You can mark track numbers at any time while recording, regardless of the type of sound source. REC while recording at the point you want to add a track mark. Be sure to remove an MD after editing because programme you made is put on record on an MD when an MD is removed. When you edit recorded tracks, there is no need for copying the MD. This lets you erase a single track one by one or all tracks at once. ⷠMove ­ Changing the order tracks Use the Move Function (see page 42) to change the track numbering. ⷠDivide ­ Marking track numbers on recorded radio programms Use the Divide Function (see page 43) to add track numbers. This lets you find your favorite phrases quickly and play them repeatedly. ⷠCombine ­ Combining recorded tracks Use the Divide and Erase Functions to erase unwanted portions, then put several phrases into a single track using the Combine Function (see page 44). ⷠUndo ­ Canceling the last edit Use this function to cancel the last edit and restore the contents of the MD to the condition before the edit (see page 45). You can use upper case, lower case, number and symbol for the titles (see page 46). The total number of tracks increases by one and all the tracks following the divided ones are renumbered. Example: Dividing track 2 into tracks B and C. While playing the MD, press ^ at the point where you want to divide. 2 While monitoring the sound, press =0 or )+ to select the starting point to be divided. You can check the display and shift the point between ­128 and +127 (±1 is about 0. Press YES again when you find the point to be divided. "Complete" appears for a few seconds and the newly created track begins playing. The new track will have no track title even if the original track was labelled. You can also divide tracks while recording. To combine the divided tracks again, use Combine Function on this page. This function lets you put several tracks or several independently recorded portions into a single track. [. . . ] The sound is not clear and there is a decrease in sound level. The programme is not recorded, which must have been recorded or edited. ⷠThe mains lead was disconnected without removing the MD from the MD deck after recording or editing. Be sure to remove an MD after recording or editing because programme you made is put on record on an MD when an MD is removed. [. . . ]