User manual SONY HANDYCAM HDR-AX2000 DATASHEET

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Don't throw away the battery with general house waste, dispose of it correctly as chemical waste. Except for European model How to use this manual ⷠThis manual mainly explains operations using the remote, but the same operations can also be performed using the buttons on the unit having the same or similar names. ⷠThis manual describes how to use this system. [. . . ] at that time , "TUNED" and "STEREO" (for an FM stereo program only) appear. If "TUNED" does not appear and the scanning does not stop Perform steps 6 and 7 while the preset number flashes. Tune in a station with a weak signal Set another station to the existing preset number After step 5, press + or ­ (or TUNING + or ­ on the unit) repeatedly to select the preset number of the station you want to store. To change the AM tuning interval, tune in any AM station first, then turn off the system. When you change the interval, all the AM preset stations are erased. You can listen to a radio station either by selecting a preset station, or by manually tuning in the station. The preset stations are retained for about half a day even if you disconnect the mains lead or if a power failure occurs. When tuner reception is poor, set CD player power off by CD power manage function. Use buttons on the unit for the operation. Repeat the procedure above and "CD POWER" and "ON" appear. When "CD POWER" and "OFF" are selected, disc access time is increased. Prepare the sound source you want to play. To start from a specific track, make a program (see "Creating your own program" on page 14). Repeatedly until "TIMER OFF" appears, then press ENTER. Or > repeatedly to set the hour, then press ENTER. Do not operate the system from the time the system turns on until the play starts (about 15 seconds before the preset time). ⷠIf the system is on about 15 seconds before the preset time, the Play Timer will not be activated. ⷠYou cannot use the optional component connected to ANALOG IN jack as the sound source for Play Timer. Set the time to stop playing following the same procedure as step 5. Or > repeatedly until the desired sound source appears. Each time you press the button, the display changes cyclically as follows: The start time, the stop time and the sound source appear in turn, then the original display returns. You can record a preset radio station from a specified time. [. . . ] Be sure to check that the label side of the disc is not sticky before using. The following types of disc should not be used: ­ Rental or used discs with attached seals where the glue extends beyond the seal. the perimeter of the seal on the disc is tacky. ­ Discs that have labels printed using a special ink that feels tacky when touched. [. . . ]