User manual SONY HANDYCAM HDR-PJ50V

[. . . ] To skip the track, press + or just wait for the next track. When you go through the CD, "INTRO PGM" stops flashing and the tracks you chose play automatically. To finish programming before hearing through the CD, press ^. To cancel INTRO PGM play, press PLAY MODE until no play mode is indicated in the display. [. . . ] ⷠDuring play, the track number and the elapsed playing time of the current track appear. ⷠBetween the tracks, the time to the beginning of the next track will appear with the "­" indication. ⷠDuring pause, the elapsed playing time of the current point flashes. Playing tracks in the order you want (RMS play) E You can program up to 22nd tracks to play in any order you choose. During play, press PLAY MODE repeatedly until "RMS" flashes. The track number and the playing order appear. When using the unit on the AC power adaptor or car battery, the display is always illuminated. (Light of the display goes out when you press p and the CD stops. ) When you use the unit on the rechargeable battery or alkaline batteries, the display is illuminated for about 5 seconds when you press an operation button. "RMS" stops flashing and the tracks you chose play in the order you specified. To cancel RMS play, press PLAY MODE until "RMS" disappears. Hours) When using ESP function off on 00 The AVLS (Automatic Volume Limiter System) function keeps down the maximum volume to protect your ears. Charge the rechargeable battery before using it for the first time. You can use either BP-DM10 or BP-DM20 rechargeable battery for this unit. You can use them in the same way, but their charging time and battery life are different. Check the model number of your rechargeable battery before using. To resume playing from the point you stopped the CD (Resume Play) J Normally, every time you stop and play, playing starts from the beginning of the CD. The resume play function, however, lets you listen to from the point at which you last turned off the Discman. You can turn off the beep that sounds as you operate your Discman. Disconnect the power source (AC power adaptor, rechargeable battery or alkaline batteries). While you press and hold down p on the main unit, connect the power source again. Insert the rechargeable battery so that the word "SONY" is facing the same direction as iillustrated inside the lid, and close the lid. [. . . ] When the battery becomes weak, indication appears in the display. When the battery is used up, "Lo batt" appears in the display. To keep the original battery capacity for a long time, recharge the battery when the battery is used up (discharged). If the battery is new or has not been used for a long time, it may not be charged completely until you charge and discharge it several times. [. . . ]