User manual SONY ICD-P520

[. . . ] The model number is located at the rear panel and the serial number is located inside the battery compartment. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. The following FCC statement applies only to the version of this model manufactured for sale in the USA. [. . . ] You can divide messages until the total number of messages in the folder becomes 99. While recording or playing back a message, press DIVIDE at the point you want to divide. When you press DIVIDE during recording: The new message number is added at the point you pressed the button, and the new message number and "DIVIDE" flash three times. The message will be divided into two; however, the messages will be recorded without a break. Tip You can divide a message during recording pause. When you press DIVIDE during playback: The message is divided into two at the point you pressed the button, and the new message number and "DIVIDE" flash three times. The message numbers of the following messages will increase by one. Press ­ or + to display the message number as the divided messages each have message numbers. You can move the recorded messages to another folder. 1 While the unit is stopped, select the In that case, reduce the number of messages to 98 or less by erasing unnecessary messages or by moving some of the messages to another folder before dividing a message. If you divide a message with an alarm setting, the alarm setting remains only with the former message divided. You cannot divide a message in the first or the last 1 second. If you divide a message frequently, the unit may become unable to divide a message. Once a message is divided, you cannot combine the divided messages with the IC recorder. Folder to which you want to move the message. The move function does not duplicate a message in another folder. When you move a message to another folder, the one in the previous folder will be deleted. Each time you press MENU/DISPLAY, the display mode will change as shown below: On the current time display If the unit is left unoperated for more than 3 seconds in the stop mode, the display will show the current time, regardless of the display mode setting. BEEP OFF: No beep sound will be heard except for the alarm and timer. HQ: You can record with the high quality sound (monaural sound). SP: You can record with better sound (monaural sound). LP: You can record for longer time (monaural sound). [. . . ] There may be conflict between the software and other driver or application. Noise may be recorded when an object, such as your finger, etc. , rubs or scratches the unit during recording. To clean the exterior, use a soft cloth slightly moistened in water. [. . . ]