User manual SONY ICF-C203

[. . . ] Do not place the unit on a surface (a rug, a blanket, etc. ) or near materials (a curtain) which might block the ventilation holes. · Should any solid object or liquid fall into the unit, unplug the unit and have it checked by a qualified personnel before operating it any further. · When the casing becomes soiled, clean it with a soft cloth dampened with mild detergent solution. Never use abrasive cleansers or chemical solvents, as they may mar the casing. [. . . ] You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Grounding or Polarization This appliance is equipped with a polarized AC power cord plug (a plug having one blade wider than the other), or with a three-wire grounding type plug (a plug having a third pin for grounding). Follow the instructions below: -For the appliance with a polarized AC power cord plug: This plug will fit into the power outlet only one way. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to have a suitable outlet installed. Do not defeat the safety purpose of the polarized plug by forcing it in. -For the appliance with a three-wire grounding type AC plug: This plug will only fit into a grounding-type power outlet. If you are unable to insert the plug into the outlet, contact your electrician to have a suitable outlet installed. Do not defeat the safety purpose of the grounding plug. Overloading Do not overload wall outlets, extension cords or convenience receptacles beyond their capacity, since this can result in fire or electric shock. When not in use Unplug the power cord of the appliance from the outlet when left unused for a long period of time. To disconnect the cord, pull it out by grasping the plug. Never pull the plug out by the cord. Power-Cord Protection Route the power cord so that it is not likely to be walked on or pinched by items placed upon or against them, paying particular attention to the plugs, receptacles, and the point where the cord exits from the appliance. Lightning For added protection for this appliance during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the appliance due to lightning and powerline surges. Object and Liquid Entry Never push objects of any kind into the appliance through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the appliance. Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION With 4­ohm loads, both channels driven from 100 ­ 10 000 Hz; rated 1. 0 W per channelminimum RMS power, with no more than 10 % total harmonic distortion in AC operation. Cleaning Unplug the appliance from the wall outlet before cleaning or polishing it. -If the appliance has been subject to excessive shock by being dropped, or the cabinet has been damaged. Servicing Do not attempt to service the appliance yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. Replacement parts When replacement parts are required, be sure the service technician has used replacement parts specified by Sony that have the same characteristics as the original parts. Press NAP repeatedly until the desired minutes is displayed. Every press changes the display as follows: (current time) Press ALARM SET RADIO. Two short beeps will confirm the setting. i (headphones) jack AC power cord Do not stick paper or tape nor write anything on the surface. Notes · Discs with non-standard shapes (e. g. , heart, square, star) cannot be played on this unit. Attempting to do so may damage the unit. · If you press CD u when there is no disc in the CD compartment, "00" flashes for about 5 seconds on the display and the unit turns off automatically. To Set the Buzzer Alarm: 1 Press ALARM SET BUZZER for a few seconds. "ALARM" and "BUZZER" appear on the display. After one beep, "ALARM" and the hour will start to flash on the display. OFF 10 120 90 20 60 30 2 Press TUNE/TIME SET + or ­ until the desired hour appears. To set the hour rapidly, hold down TUNE/ TIME SET + or ­. The NAP indicator turns on, " " and the NAP time is displayed for a few seconds. NAP timer starts counting down the NAP time. When selected NAP time has passed, the beep sound comes on, and the NAP indicator and " on the display flash. " NAP indicator Various Modes of CD Playback You can play tracks repeatedly or in random order. [. . . ] The "MEGA BASS" system produces a powerful bass sound. AM FM1 FM2 TV 3 4 5 WEATHER 3 Press TUNE/TIME SET + or ­ until the correct year appears in the display. Repeat steps 3 and 4 to set the month, day, hour, and minute. After setting the minute, press CLOCK to start the counting of the seconds, and you will hear two short beeps. Close the lid Press TUNE/TIME SET + or ­ until the desired hour appears. To set the hour rapidly, hold down TUNE/ TIME SET + or ­. ALARM ON-- If you set the CD alarm and there is no disc in the CD player, the buzzer alarm will sound in its place at the time set. For the buzzer alarm, the beeping of the alarm becomes more rapid after every few seconds in three progressive stages. [. . . ]