User manual SONY LBT-XB60

[. . . ] The model and serial numbers are located on the rear panel. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] You can record tracks from all the CDs in the order you want. When programming, make sure the playing times for each side do not exceed the length of one side of the tape. Turn the jog dial until the desired track appears in the display. Disc number Track number "STEP" and the programmed playing order appear, followed by the total playing time. Select A to record on one side or ß (or RELAY) to record on both sides. After the last track, "CHECK END" appears. Press PLAY MODE repeatedly until "PROGRAM" or "SHUFFLE" disappears from the display. Repeat steps 5 through 7 to program additional tracks to be recorded on side A. Skip step 5 to select tracks from the same disc. Note that you cannot use Tape Select Edit for discs containing more than 20 tracks. The required tape length for the CD in the playing position appears, followed by the total playing time for sides A and B. note You cannot use this function when Program Play mode has been set. After clearing the entire program (see "Clear the entire program" in the table on page 22), follow the above procedure. Skip step 5 to select tracks from the same disc. Button (for the front side) lights up green. With the loop function, you can repeat part of a CD during playback. This lets you create original recordings. With the flash function, you can "flash" the CD sound during playback. This lets you create original recordings. Playback at the point you want to start the Loop function, and release to resume normal playback. to adjust the loop length Turn the jog dial while holding LOOP (or press MUSIC MENU B/b while holding LOOP on the remote) to select different loop lengths. Playback at the point you want to start the Flash function, and release to resume normal playback. [. . . ] The demonstration appears automatically the first time you plug in the power cord, or if there is a power outage lasting longer than half a day. In this case, reset the following: -- Clock setting (see "Step 2: Setting the time") -- Press DISPLAY/DEMO while the system is off. Insert only the stripped portion of the speaker cord into the SPEAKER jack. inserting the vinyl portion of the speaker cord will interfere with the speaker connection. [. . . ]