User manual SONY RDP-XA900IP

[. . . ] Personal Audio Docking System Operating Instructions GB Mode d’emploi Manual de instrucciones FR ES RDP-XA900iP WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to dripping or splashing, and do not place objects filled with liquids, such as vases, on the apparatus. To reduce the risk of fire, do not cover the ventilation opening of the apparatus with newspapers, tablecloths, curtains, etc. Do not place the naked flame sources such as lighted candles on the apparatus. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. [. . . ] 2 3 4 5 Notes • When an error occurred, the UPDATE indicator flashes quickly and all other indicators light up. • You cannot operate the unit until updating has completed. • It may take about 20 minutes to update the software. The time required depends on the size of the update content and type of Internet connection you are using. • Do not disconnect the AC power cord during the update. Notes • If each terminal is connected to a different component, and both are playing back, the unit will output sound from the component connected to the DIGITAL (OPT) terminal. • When you use the ANALOG terminal and the volume is low, adjust the volume level on the connected equipment first. If the volume is still too low, adjust the volume level on the unit. You may need to change the sound setting of the connected component. If digital audio signals or other signals that this unit does not support are input, the AUDIO IN indicator flashes and sound is not output. 20GB Initializing the Unit You can initialize the unit. All settings of the unit are reset to the factory default settings when you initialize the unit. While holding down VOLUME –, hold down ?(Hold both buttons down for at least 5 seconds. Tip You can reset only the network settings of the unit to the factory default settings using the RESET (NETWORK) button (page 8). 21GB Additional Information The unit turns off automatically. • The unit enters the selected standby mode when it is idle for 20 minutes. • Disconnect and reconnect the AC power cord of the unit, then turn the unit on again. This unit does not operate if you press the buttons of this unit or those of the remote control. • Buttons do not work while initializing or starting up. • Buttons do not work while you are updating the software. /1 button do not work in the network standby or standby mode. [. . . ] HIGH RISK ACTIVITIES The SONY SOFTWARE is not fault-tolerant and is not designed, manufactured or intended for use or resale as on-line control equipment in hazardous environments requiring fail-safe performance, such as in the operation of nuclear facilities, aircraft navigation or communication systems, air traffic control, direct life support machines or weapons systems, in which the failure of the SONY SOFTWARE could lead to death, personal injury or severe physical or environmental damage (“High Risk Activities”). SONY and its suppliers specifically disclaim any express or implied warranty of fitness for High Risk Activities. 31GB EXCLUSION OF WARRANTY ON SONY SOFTWARE You expressly acknowledge and agree that use of the SONY SOFTWARE is at your sole risk. The SONY SOFTWARE is provided “AS IS” and without warranty of any kind, and SONY, its vendors and SONY’s licensors (for purposes of this SECTION only, collectively, “SONY”) EXPRESSLY DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. [. . . ]