User manual SONY RM-V22

[. . . ] 3 Enter one of the codes from the following table, correspond to the component type you're setting up: Component type VCR Receiver CD player Tape deck TV Cable box This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] 5 If you haven't already done so, finish setting up the component by completing the procedures in "Step 1: Entering the Code Number". For example, if you're setting up a CD player, you would press and release 5. 4 Press and release the ENTER button to store the code number in the Commander's ENTER memory. To finish setting up the component, go to "Step 1: Entering the Code Number" and complete the procedures that are described. Before you can start using the Commander, you must first set it up. This manual describes everything you need to know to set up the Commander, including: · Presetting the Commander with the codes for your TV, VCR, Cable box, and other audio components. 5 To record, press " while pressing r. 6 To pause 7 To rewind 8 To play 9 To stop 0 To light up the Commander's buttons. (The light will automatically turn off if no button is pressed for more than 10 seconds. If you've tried all the code numbers listed for your component and you still cannot get the Commander to work (or if your component is not listed in this manual), try these steps. 1 Power on the component you want to set AV2 AV1 CBL VCR TV up with its power switch. Then set the slide switch on the commander to the position that corresponds to the component. Then press and release the POWER button. 4 Repeat step 3 until your component powers off. If you're using the Commander with a Sony TV, VHS VCR, receiver, and CD player, you won't need to preset the Commander before you start using it. To set up the Commander to use with other (non-Sony) manufacturer's components, you'll need to follow the instructions in this manual to preset the Commander with the correct code number for your components. 1 Power on the component you want to set up with its power switch. VOL CH 3 When the component powers off, check that the commander is operating the other functions of your component, such as channel and volume control. The Commander can be set up to operate only one component of each category (VCR, AV1, AV2, CBL, or TV position of the slide switch) at a time - unless their code numbers happen to be the same. For example, you cannot set up the Commander to operate a Sony TV and a Panasonic TV at the same time (because they use different code numbers). Pressing the CH+ and POWER buttons repeatedly will try every available code until the correct one is found. It may take up to about 50 to 60 tries until the correct code number is located. [. . . ] If all the codes fail to work (or if your component is not listed in this manual), try using the procedures in "Searching for the Correct Code. " · Check that you're aiming the Commander directly at the component, and that there are no obstructions between the Commander and the component. ⷠMake sure the batteries you're using are not worn out, and that they're inserted correctly. Note that whenever you remove the batteries - to replace them, for example - the code numbers you've set are automatically eased and must be reset. [. . . ]