User manual SONY SLT-A57K

[. . . ] Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS1362, (i. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. [. . . ] You can also use the VPS/PDC function for a source connected to one or more of the LINE inputs. To record a programme from your set top box If you connect a set top box and the VCR, you can record a programme from your set top box. Box, select the programme for which you want to make a timer 3 Follow steps 1 through 6 above. To use the VCR after setting the timer To use the VCR before a recording begins, just press ?You can also do the following tasks while the VCR is recording: · To set the programme position, you can also use the PROG +/­ or programme number buttons. ⷠTo set the programme position with a two digit number, press - (ten's digit) button followed by the programme number buttons. ⷠTo set the line input video source, you can also use the PROG +/­ buttons. ⷠTo set the tape speed, you can also use the SP/LP button. ⷠWhen you are recording a programme in the SP mode and the remaining tape becomes shorter than the recording time, the tape speed is automatically changed to the LP mode. Note that some interference will appear on the picture at the point the tape speed is changed. If you want to keep the same tape speed, set AUTO LONG PLAY to OFF in the OPTIONS-1 menu (page 77). ⷠTo set the programme position with a two digit number, press - (ten's digit) button followed by the programme number buttons. ⷠTo set the line input video source, you can also use the PROG +/­ buttons. ⷠTo set the tape speed, you can also use the SP/LP button. ⷠWhen you are recording a programme in the SP mode and the remaining tape becomes shorter than the recording time, the tape speed is automatically changed to the LP mode. Note that some interference will appear on the picture at the point the tape speed is changed. If you want to keep the same tape speed, set AUTO LONG PLAY to OFF in the OPTIONS-1 menu (page 77). ⷠEven if you set TIMER OPTIONS* to VIDEO Plus+ in the OPTIONS-2 menu, you can set the timer manually. Press MENU to select TIMER, then go to step 2. ⷠTo check, change, or cancel the programme setting, press </, to choose LIST, then press OK in step 2. When setting the timer with VPS/PDC* signals, enter the start and stop times exactly as indicated in the TV programme guide. Otherwise, the VPS/PDC function won't work. [. . . ] Check that the VPS/PDC time you set is the correct one (there might be a mistake in the TV programme guide). If the broadcast you wanted to record did not send the good VPS/PDC information, the VCR will not start recording. ⷠIf the reception is poor, the VPS/PDC signal might be altered and the VCR might not start recording. The SYNCHRO REC button turns off while recording or does not go back to recording standby mode. [. . . ]