User manual SONY SRS-BTV25

[. . . ] Turn up the volume of the source device as high as possible to the extent that sound is not distorted. Supplied accessories AC adaptor (AC-E1320D1) (1) AC power cord (1) Reference Guide (this document) (1) Design and specifications are subject to change without notice. By using the Bluetooth connection, you can listen to the sound from a Bluetooth device with the system wirelessly. Turn down the volume of the source device to the point where the sound is no longer distorted. [. . . ] Pairing mode is cancelled and the system is turned off after about 5 minutes. If the pairing mode is cancelled while performing this procedure, start over from step 2. * Even when the Bluetooth standby function is activated, the indicator will be off if there is no pairing information. The nameplate indicating Sony trademark, model number and electrical rating is located on the bottom exterior of this unit. Before operating the system, be sure that the operating voltage of the system is identical with that of your local power supply. Bring this system and the Bluetooth device closer together. " If "SRS-BTV25" is not displayed, repeat from step 2. By using the Bluetooth standby function, you can make the system turn off temporarily and wait for the Bluetooth connection. Make sure the AC adaptor is connected to a wall outlet (mains). If pairing information has not been memorised, the system enters pairing mode automatically when the BLUETOOTH PAIRING button is pressed. There is no need to hold the BLUETOOTH PAIRING button for any more than 2 seconds. And press the / button for any more than 2 seconds while the system is turned on. the system turns off and the (BLUETOOTH) indicator (blue) flashes. If you start the Bluetooth connection, the system turns on automatically and starts communication. When connecting or disconnecting the AC power cord (mains lead), turn off the system beforehand. To avoid damaging the system, do not use any other AC adaptor. Do not leave the system in a location near heat sources, or in a place subject to direct sunlight, excessive dust, moisture, rain or mechanical shock. When pairing, be sure to place both the Bluetooth devices within 1 m of each other. Some devices cannot display a list of detected devices. When waiting for the Bluetooth connection, you can reduce power consumption by using the Bluetooth standby function, rather than leaving the system turned on. Use Bluetooth devices within 10 m (line of sight) of the system. Maximum communication range may shorten under the following conditions. [. . . ] If you run into any problems using this system, use the following checklist. Should any problem persist, consult your nearest Sony dealer. To be able to use the Bluetooth function, the Bluetooth device to be connected requires the same profile as the system's. Note also that even if the same profile exists, devices may vary in function depending on their specifications. [. . . ]