User manual SONY STR-DE545

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Should any solid object or liquid fall into the cabinet, unplug the receiver and have it checked by qualified personnel before operating it any further. Before operating the receiver, check that the operating voltage is identical with your local power supply. [. . . ] * * However, this indicator does not light when the recording format is 2/0 or 2/0 Pro logic. 8 Tuner indicators These indicators light up when using the receiver to tune in radio stations, etc. see pages 37 - 43 for tuner operations. 9 Playback channel indicators The letters light up to indicate the channels being played back. L: Front Left R: Front Right C: Center (monaural) LS: Left Surround RS: Right Surround S: Surround (monaural or the rear components obtained by Pro Logic processing) The boxes around the letters light up to indicate the speakers used to playback the channels. LFE will light up when the disc being played contains the LFE (Low Frequency Effect) channel and when the sound of the LFE channel signal is actually being reproduced. 2 PRO LOGIC Lights up when the receiver applies Pro Logic processing to two channel signals in order to output the center and surround channel signals. ** ** However, this indicator does not light if the center and rear speakers are set to "NO", or the SPEAKER button is set to "OFF" and the A. Or NORMAL SURROUND sound fields are selected. 3 OPT Lights up when the source signal is a digital signal being input through the OPT terminal. 4 COAX Lights up when the source signal is a digital signal being input through the COAX terminal. 5; Lights up when Dolby Digital (AC-3) signals are input. 6 dts Lights up when DTS signals are input. Note When playing a DTS format disc, be sure that you have made digital connections and that INPUT MODE is NOT set to ANALOG (see 3 on page 23). Source sound displays The letters (L, C, R, etc. The box around the letters varies to show how the receiver downmixes the source sound (based on the speakers settings). When using music sound modes such as HALL or JAZZ CLUB, the receiver adds reverberation based on the source sound. The following table shows how the indicators light up when using AUTO FORMAT DECODING mode. Although the table below shows almost all of the configurations available from multi channel surround signals, the ones marked " " are the most common. Source sound and Output Channel Display Input Channel Display All speakers present Rear speakers absent * Signals with Dolby surround encoded flag OFF ** Signals with Dolby surround encoded flag ON *** The sampling rate is displayed. The receiver performs Pro Logic decoding and the display conforms to 2/0** when using the following movie sound modes with 2/0* or STEREO PCM format signals. When using music sound modes such as HALL or JAZZ CLUB with standard audio formats e. [. . . ] Anslut laserskivspelaren först till en RF-demodulator och sedan den optiska eller koaxiala, digitala utgången på RF-demodulatorn till OPTICAL eller COAXIAL DVD/LD IN på denna receiver. När en MD-spelare, som har anslutits till en dator, ansluts till denna receiver via styrkopplingarna CONTROL A1 : observera att du inte kan styra receivern när du använder Sonys program MD Editor för att styra MD-spelaren. Om du har fristående ljudkomponenter (utom PHONO) Använd ljudkablarna för att ansluta LINE OUT­ kontakterna på CD­spelaren, kassett­ eller MD­däcket till AUX AUDIO IN­kontakterna på mottagaren, så kan du lyssna till stereokällor med surroundljud. Anslut högtalartrådarna rätt: + till + och ­ till ­. [. . . ]