User manual SONY STR-DE875

[. . . ] Don't throw away the battery with general house waste, dispose of it correctly as chemical waste. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. [. . . ] Cinema Studio EX is the integrated mode which operates these elements simultaneously. The receiver lets you apply the last selected sound field to a program source whenever it is selected (Sound Field Link). For example, if you listen to CD with "JAZZ" as the sound field, change to a different program source, then return to CD, "JAZZ" will be applied again. When sound signals with a sampling frequency of 96 kHz are input, the sound signals are output in stereo automatically, and the sound field is turned off. The effects provided by the virtual speakers may cause increased noise in the playback signal. ⷠWhen listening with sound fields that employ the virtual speakers, you will not be able to hear any sound coming directly from the surround speakers. 1 SW: Lights up when sub woofer selection is set to "YES" (page 17) and the audio signal is output from the SUB WOOFER jacks. * Does not light up when you connect headphones to the PHONES jack. 7 DTS: Lights up when DTS signals are input. When playing a DTS format disc, be sure that you have made digital connections and that INPUT MODE is NOT set to "ANALOG" (page 21). 6 ; PRO LOGIC II: "; PRO LOGIC" lights up when the receiver applies Pro Logic processing to 2 channel signals in order to output the center and surround channel signals. Lets you compress the dynamic range of the sound track. This may be useful when you want to watch movies at low volumes late at night. To reproduce the sound track with no compression, select "OFF". ⷠTo reproduce the sound track with the dynamic range intended by the recording engineer, select "STD". Resetting customized sound fields to the factory settings " appears in the display and all sound fields are reset at once. Before receiving broadcasts, make sure you have connected FM and AM antennas to the receiver (page 7). Do not press any button on the receiver or supplied remote during autobetical operation. ⷠIf you move to another area, repeat this procedure to store stations in your new area. If you move the antenna after storing stations with this procedure, the stored settings may no longer be valid. If this happens, repeat this procedure to store the stations again. You can enter a frequency of the station you want directly by using the numeric buttons on the supplied remote. [. . . ] Make sure you select AV2 as the command mode of the receiver (page 36). ⷠRemove any obstacles in the path between the remote and the receiver. ⷠReplace both batteries in the remote with new ones, if they are weak. ⷠMake sure you select the correct input selector on the remote. [. . . ]