User manual SONY STR-SE501

[. . . ] Don't throw away the battery with general house waste, dispose of it correctly as chemical waste. The instructions in this manual are for model STR-SE501. Check your model number by looking at the lower right corner of the front panel. You can also use the controls on the supplied remote if they have the same or similar names as those on the receiver. [. . . ] The Dolby Corporation web page can help you distinguish Surround EX films. *3 Software encoded with a flag to denote it has both Surround EX and 5. 1 channel signals are DVD specific signals not used in movie theaters. *5 When two surround back speakers are connected, the output channel will be 7. You can assign the audio input for each function. This function is convenient in the following cases. (Example) When you have two DVD players and no digital audio input jack is available for the second DVD player. Connect the first DVD player to the DVD/LD COAXIAL IN jack and connect the second DVD player to the DVD/LD OPTICAL IN jack. Also, connect the analog audio/video output jacks on the second DVD player to the VIDEO 2 INPUT jacks on the receiver. Whose audio input mode you want to assign. When you select a function for which an audio input is assigned, the AUDIO SPLIT button lights up. These settings are applied to all sound fields. 1 Start playing a source encoded with Initial setting: 0 dB You can adjust from ­20 dB to +10 dB in 0. 4 While monitoring the sound, turn the Initial setting: 0 dB You can adjust from ­20 dB to +10 dB in 0. Initial setting: 0 dB Lets you increase the level of the MULTI CHANNEL IN 1/MULTI CHANNEL IN 2 sub woofer channel by +10 dB. This adjustment may be necessary when connecting a DVD player to the MULTI CHANNEL IN 1/MULTI CHANNEL IN 2 jacks. The sub woofer level from DVD players is 10 dB lower than Super Audio CD players. Initial setting: OFF Lets you output the test tone sequentially from each speaker. When set to "AUTO", the test tone is output from each speaker automatically. When set to "FIX", you can select which speaker will output the test tone. Initial setting: OFF Lets you output the test tone sequentially from two adjacent speakers. Initial setting: OFF Lets you output the source sound (instead of the test tone) sequentially from two adjacent speakers. [. . . ] ⷠSound fields do not function for the signals with a sampling frequency of more than 48 kHz. ⷠWhen the INPUT MODE is set to "AUTO MULTI CH 1 (or 2)" and no digital signal is input, or INPUT MODE is set to "MULTI CH 1 (or 2) FIXED", you cannot change the sound field (page 42). Dolby Digital or DTS multi channel sound is not reproduced. When recording from a digital component, make sure the INPUT MODE is set to ANALOG 2CH FIXED (page 42) before recording with a component connected to the analog MD/DAT or TAPE terminals. [. . . ]