User manual SONY VAIO VGN-FW510F

[. . . ] Refer all servicing to qualified service personnel. !WARNUNG Die Anleitung ist nur für qualifiziertes Fachpersonal bestimmt. Alle Wartungsarbeiten dürfen nur von qualifiziertem Fachpersonal ausgeführt werden. Um die Gefahr eines elektrischen Schlages, Feuergefahr und Verletzungen zu vermeiden, sind bei Wartungsarbeiten strikt die Angaben in der Anleitung zu befolgen. [. . . ] Insert the RC-91 board removed in step 3 in the right most slot. Insert the FC-88 board in the second slot from the right most slot. n Check that the FC-88 and RC-91 boards are securely connected to the motherboard (MB-951 board). RC-91 board Levers FC-88 board RC-91 board A VAIO VGN-FW510F IMM 1-29 (E) 1-8. Installing the HKCU-951/953 Rear side (SDI-73 board) 1. Remove the two screws and remove the blank panel by holding the handle. Remove the two screws and remove the DIF-124 board. n Store the removed blank panel in a safe place. 3. Insert the DIF-124 board removed in step 2 in the left most slot. Insert the SDI-73 board in the second slot from the left most. Because there is a difference of the depth between the upper groove and the lower groove, insert the SDI-73 (or DIF-124) board in a straight line after inserting it in the lower groove. Check that the SDI-73 and DIF-124 boards are securely connected to the motherboard (MB-951 board). Turn off the power and disconnect the plug from the outlet. Slide the front panel in the direction of the arrow to extract the pin from the potbellied hole and remove the front panel. Pin Potbellied hole 11. Connect the flexible card wire to the connector (CN2) of the AU-281 board. Do not insert the flexible card wire sideways. Insert it securely to the deep end as shown in the Fig 1. If the connection is not performed correctly, it may cause an failure. Life of flexile card wire will be significantly shortened if it is folded. Be very careful not to fold the flexible card wire. Install the connector so that the excessive force is not given to it. Close the front panel of the RM-B750 in the direction of the arrow and secure it with the two screws (with drop-safe). NG OK Insulated surface (Blue) Insulated surface (Blue) B3 x 5 Front panel 9. Insert the pin into the potbellied hole of the front panel of the RM-B750 removed in step 4 and slide the pin in the direction of the arrow. [. . . ] State of the operation mode on the RC-91 board (Normal/ Test) Displays when the DIF-124 board is installed in the rear correctly. Displays the type of signal that is output from the SD SDI OUT1 connector on the rear panel. (SD SDI/VBS)*10 Displays the type of signal that is output from the SD SDI OUT2 connector on the rear panel. (SD SDI/VBS/MONI SDI)*11 2 3 3 4 5 6 *10 : When the HKCU-951 is installed, set the switch with S103 on the EN145 board. [. . . ]