User manual SONY VAIO VPCB11GGX/B

[. . . ] Microsoft, MS-DOS, and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. PCMCIA is a trademark of the Personal Computer Memory Card International Association. Centrino, Intel, and Intel Core are trademarks or registered trademarks of Intel Corporation or its subsidiaries in the United States and other countries. Realtek is a trademark of Realtek Semiconductor Corporation. Bluetooth is a registered trademark of Bluetooth SIG, Inc. All other trademarks mentioned herein are the property of their respective owners. [. . . ] You can continue operating but you will have to use setup utility default values or reconfigure your setup utility every time you turn off your notebook. System BIOS shadowed System BIOS copied to shadow RAM. *System CMOS checksum bad ­ run SETUP BIOS CMOS RAM has been corrupted or modified incorrectly, perhaps by an application program that changes data stored in BIOS memory. *System RAM Failed at offset: nnnn System memory failed at offset nnnn of in the 64k block at which the error was detected. This means that there is a fault in your built-in memory. If you continue to operate, you risk corrupting your data. Contact your support representative for repairs. nnnn System RAM Passed Where nnnn is the amount of system memory in kilobytes successfully tested. *System timer error The timer test failed. The main clock that operates the computer is faulty. Contact your support representative for repairs. To verify/ change the boot-up priority (rather than booting-up from the hard drive or an external floppy disk drive), perform the following steps: 1. Start your system and press the [F2] key when the Fujitsu logo appears. Using the arrow keys, go to the Boot menu. Arrow down to the Boot Device Priority submenu. If "Optical Media Drive" or "CD-ROM Drive" is not at the top of the list, arrow down to the drive in the list, and press the space bar (or the + key) to move it to the top of the list. (The system attempts to boot from the devices in the order in which they are listed. ). Note that the BIOS for some systems will indicate "CD-ROM Drive", even when a DVD drive is connected. If you have an external drive connected, proceed to step 6; otherwise, proceed to step 7. If you have an external drive connected: 4. In the list, check off all the components you want to install. If you want to install all components, click [Select All]. [. . . ] If the difficulties persist, then try the following procedure. Click Start, Control Panel, Administrative Tools, and Local Security Settings. Expand Local Policies, expand Security Options, and double-click Accounts: Limit local account use of blank passwords to console login only. Dialog appears after OmniPass authentication during Windows Logon After installing OmniPass on your system, you can choose to logon to Windows using OmniPass. [. . . ]