User manual SONY VPCEG26FX

[. . . ] You may need them when maintaining or moving this unit. Book 2 ページ ２０１３年１月１５日　火曜日　午後１時４分 Safety precautions WARNING Unit ≥ To reduce the risk of fire, electric shock or product damage, – Do not expose this unit to rain, moisture, dripping or splashing. € Do not place objects filled with liquids, such as vases, on this unit. refer servicing to qualified service personnel. [. . . ] 5 VQT4U48 ENGLISH SC-NE1_EG~VQT4U48. Book 6 ページ ２０１３年１月１５日　火曜日　午後１時４分 Bluetooth® operations By using the Bluetooth® connection, you can listen to the sound from the Bluetooth® audio device from this unit wirelessly. ‰ Refer to the operating instructions of the Bluetooth® device for details. Pairing Bluetooth® devices Preparation ≥ Turn on the Bluetooth® feature of the device and place the device near this unit. ‰ If this unit is already connected to a Bluetooth® device, disconnect it. Bluetooth® transmission mode You can change the transmission speed to prioritize transmission quality or sound quality. ‰ If “PAIRING” is indicated on the display, go to step 3. Press [3, 4] to select the mode and then press [OK]. MODE 1: Emphasis on connectivity MODE 2: Emphasis on sound quality Select “SC-NE1” from the Bluetooth device’s Bluetooth® menu. ® Start play on the Bluetooth® device. ‰ You can register up to 8 devices with this unit. While pressing and holding [ / AUX] on the unit, press and hold [SOUND] on the remote control until the unit’s display shows “REMOTE 2”. Press and hold [OK] and [SOUND] on the remote control for at least 4 seconds. Display brightness The brightness of this unit’s display can be changed. ‰ To change the mode back to “REMOTE 1”, repeat the steps above but replace the button pressed on the remote control from [SOUND] to [ , AUX]. ‰ To cancel the dimmer, select “OFF” in step 2. Automatic standby As a factory preset, this unit will always turn off automatically if there is no sound output and no operation for approx. ‰ To turn automatic standby on, select “ON” in step 2. ‰ When connected to a Bluetooth® device, the automatic standby function does not work. If you are in doubt about some of the check points, or if the solutions indicated in the following guide do not solve the problem, consult your dealer for instructions. To return all settings to the factory preset When the following situations occur, reset the memory: ≥ There is no response when buttons are pressed. ‰ You want to clear and reset the memory contents. [. . . ] ‰ Refer to step 2 of “Wall mount instructions” for details about the required screws. ‰ Be sure to attach the fall prevention cord as a secondary safety measure. Installation accessories ∫ Supplied accessories ≥ 1 Safety holder ≥ 1 Screw ≥ 2 Wall mount brackets Wall mount instructions Before installation, turn the unit off and disconnect the AC mains lead from the mains socket. ˆ Additionally required accessories (commercially available) ≥ 4 Wall mount bracket fixing screws ≥ 1 Safety holder fixing screw ≥ 1 Fall prevention cord* ≥ 1 Screw eye * Use a cord that is capable of supporting over 33 kg (with a diameter of about 1. [. . . ]