User manual SONY XAV-C1

[. . . ] This label is located on the bottom of the chassis. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ] "SOUND" setting allows you to adjust the sound according to the playback conditions and connected equipment. Reducing the audio output level of the REAR MONITOR OUT if the playback sound is distorted. Select this if the playback sound from the speakers (rear monitor) is distorted. This setting is available only for DVD or VCD. You can adjust the output level of PCM, Dolby Digital or DTS separately to reduce the volume level differences between disc and format. When an optional power amplifier is connected, and you are not using the built-in amplifier, the beep does not sound even if it is set to Beep On. The beep sound for warning will sound even if it is set to Beep Off. You can also touch the desired point directly to adjust the balance. When you connect the back camera to AUX3 jack, set to "Back Camera". To adjust the position of the back camera while viewing the image of the camera, set to "Normal". normal · Select this when you connect the other components other than back camera to AUX3 jack. Select this to test view while connecting the back camera. You can adjust the position of the back camera while viewing the image of the camera without setting the shift lever to the "R(reverse)" position. However, note that the image of the camera will be displayed only when the parking brake is set. Back Camera Select this when you connect the back camera to AUX3 jack. The Demo screen is displayed only when the power is off. If the touching position does not correspond with the proper item, you will need to adjust the touch panel position. Touch 1, 2 and 3 of the touch panel in order. You can switch the NTSC/PAL system of the back camera in the AUX 3 mode. Press and hold SEEK + of the main unit for 3 seconds while in AUX3 mode. The short beep sounds and NTSC/PAL system is now switched. This setting is available also when AUX 3 is set to "Normal". [. . . ] Halogenated flame retardants are not used in cabinets. VOC (Volatile Organic Compound)-free vegetable oil based ink is used for printing the carton. Sections of a picture or a music feature that are smaller than titles. A disc that contains up to 8 hours of moving pictures even though its diameter is the same as a CD. [. . . ]