User manual SONY XDR-S56DBP

[. . . ] 4-266-152-11(1) WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. [. . . ] The polarity of the plugs of other manufacturers may be different. Failure to use the supplied AC power adaptor may cause the unit to malfunction. Press ·DAB/FM SC for more than 2 seconds to receive the desired secondary component. "SC " appears while the secondary component is received. Turning / or pressing ·DAB/FM SC does the following: DC IN 6V Aerial Improving the reception (See fig. ) DAB Band-III/FM: Extend the telescopic aerial and adjust the length and the angle for best reception. Note Adjust the direction of the aerial by holding it at the bottom. The aerial can be damaged if you move the aerial with excessive force. Note When the selected secondary component is finished, the unit returns automatically to the primary component. Initial setting for the DAB When the batteries are installed, or when the AC power adaptor is plugged in for the first time after purchase (or after resetting), pressing the POWER button on the unit will scan and create a list of receivable broadcasts If you wish to scan for DAB broadcasts again, or when the unit is reset, do the following: 1 2 3 4 Adjust the aerial accordingly. Hold down AUTO TUNE for more than 2 seconds. Press PRESET/ENTER. " " appears in the display. No sound will be heard, and "" appears in the display. When finished, the unit receives the first service in alphabetical order stored by the DAB scan. RESET button Notes If you do not operate within 65 seconds, the initial scan mode will be cancelled. If no broadcasts are found by the DAB scan, " " will be displayed. To cancel the DAB scan halfway, press AUTO TUNE. Any services received before cancellation are added to the list of receivable services. If the batteries are removed for a certain period, the received history list will be deleted, requiring you to scan again. Initialization will erase any DAB services registered as PRESET. If you change the unit's location of use, or want to add a new service after initial setting, press and release AUTO TUNE. " " appears in the display and the unit will automatically scan and create a list of receivable services. DAB or DAB+ may not be receivable, depending on the country/region in which this unit is used. Presetting your favourite services or stations There are two ways to preset services, Direct Preset and Preset Mode. You can preset 10 services in DAB and 10 stations in FM, including 3 services stored on the Direct Preset buttons (PRESET 1 ­ 3). You can enjoy any three preset services as Direct Presets, for immediate recall by pressing one of the PRESET 1 ­ 3 buttons. Preset services you use often to Direct Preset for your convenience. Changing the display (DAB only) To change the display mode Press DISPLAY. The selected display mode remains even if you turn the unit off and on again, or change the band. [. . . ] The clock settings, and the services you have preset, etc. , will revert to the factory preset. DAB: Each time you press DISPLAY while the first line is displayed as stretched, it changes as follows: Component label Dynamic label PTY label Service label Ensemble label Frequency Clock BIT rate Signal level Component label FM: Frequency Clock Frequency Holding down DISPLAY for more than 2 seconds returns the display to normal. Precautions Operate the unit only on the power sources specified in "Specifications". For battery operation, use four LR6 (size AA) alkaline batteries. For AC operation, use only the supplied AC power adaptor. Do not use any other type of AC power adaptor. [. . . ]