User manual SONY XM-GS400

[. . . ] This symbol indicates the presence of a hazard that may result in death or severe personal damage if the given instructions are not strictly followed. This symbol indicates the presence of a hazard that may result in burn or injury, and property damage if the given instructions are not followed. The following three types of symbols (signal marks) are used as indicators of caution and danger. Awareness of Indicates that a dangerous situation may occur caution if you ignore the instruction. [. . . ] For the disposal of the N8551-34F Built-In AIT and its cartridge, observe the waste disposal rules of your local government. If a Built-In AIT failure occurs because you have used a device or interface cable of another manufacturer (the third party) or those which have not been approved by NEC, you may not be provided with the NEC warranty service. Microsoft, the logo of Microsoft and Windows NT are registered trademarks of the Microsoft Corporation in the United States and other countries. advanced Intelligent Tape is a trademark of the Sony Corporation. The company and product names contained in this manual are trademarks or registered trademarks of the respective companies. All names used in the sample applications are fictitious. They have no relation with any product, party or individual names. (1) Reproduction of this document or portions thereof without prior approval is prohibited. (2) The information contained in this document is subject to change at any time, without prior notice. (3) Reprinting or changing of this document without prior approval of NEC is prohibited. (4) All efforts have been made to ensure that the contents of this manual are correct; however, should any doubts arise, or errors or missed entries be detected, NEC would greatly appreciate it if our dealers are informed about it. It can also read data recorded on AIT data cartridges with conventional AIT drives. (70 GB can be recorded when using twice the average compression rate (for AIT1 (tape length: 230 m) data cartridges). Please use Sony AIT data cartridges (AIT1 (tape length: 170 m or 230 m)) with this unit. Using other types of AIT data cartridges may cause read and write errors. 14) Ventilation hole EJECT button Press this button when ejecting the AIT cartridge from the Built-In AIT. Setting the Built-In AIT - Setting with the jumper pins You can change the following settings with the jumper pins on the rear of the Built-In AIT. "Without strap" means that one strap is attached to one of the two pins, or that the strap has been removed altogether. If you remove the strap, make sure you store it in a safe place. "With strap" means a status that the straps are attached to two pins. "Without strap" means a status that no strap is attached to either pin or it is attached to one of two pins. Set SCSI ID which is used by the Built-In AIT. [. . . ] â· Do not apply strong shock. Take due consideration not to adhere thinner or alcohol to the cartridge. If an AIT data cartridge that you are using is in the case below, you must replace it. â· When the AIT data cartridge is given a strong shock, for example, when falling, and damaged. [. . . ]