User manual SONY XM-GTR3301D

[. . . ] Halogenated flame retardants are not used in printed wiring Turn off the power switch. Make sure the speaker cord and ground wire are securely connected. 2­8 Make sure to place the unit in a well ventilated location. The power connecting wires are installed too close to the RCA pin cords. [. . . ] If no power is being supplied to the car audio unit, check the connections. This power amplifier employs a protection circuit* to protect the transistors and speakers if the amplifier malfunctions. Do not attempt to test the protection circuits by covering the heat sink or connecting improper loads. Do not use the unit on a weak battery as its optimum performance depends on a good power supply. For safety reasons, keep your car audio unit volume moderate so that you can still hear sounds outside your car. If the fuse blows, check the power connection and replace both the fuses. If the fuse blows again after replacement, there may be an internal malfunction. When replacing the fuse, be sure to use one matching the amperage stated above the fuse holder. Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. This amplifier is provided with a protection circuit that operates in the following cases: - when the unit is overheated - when a DC current is generated - when the speaker terminals are short-circuited The color of the POWER/PROTECTOR indicator will change from green to red, and the unit will shut down. If this happens, turn off the connected equipment, take out the cassette tape or disc, and determine the cause of the malfunction. If the amplifier has overheated, wait until the unit cools down before use. Notice for customers: the following information is only applicable to equipment sold in countries applying EU directives If you have any questions or problems concerning your unit that are not covered in this manual, please consult your nearest Sony dealer. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. the recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. For any service or guarantee matters please refer to the addresses given in separate service or guarantee documents. Mount the unit either inside the trunk or under a seat. [. . . ] However, this function is not guaranteed for all car audio units. Notesonthepowersupply Connect the +12 V power supply wire only after all the other wires have been connected. Be sure to connect the remote control wire of the car audio unit to the remote terminal. When using a car audio unit without a remote output on the amplifier, connect the remote input terminal (REMOTE) to the accessory power supply. [. . . ]