User manual SONY XS-W3521 DATASHEET

[. . . ] When combined with the HT PS300 powered subwoofer, a THX controller, and THX amplifiers, the SONY HT Series loudspeaker system will deliver stateof-the-art home theater experience to your home. The HT Series loudspeakers also deliver clear accurate stereo music reproduction. one. Speaker Placement Properly placing your speaker components is vital to achieving the maximum sonic performance. [. . . ] Please follow the recommendations in this guide, to properly position your speakers. Note: Do not attempt to install any type of mounting brackets onto your speakers. Drilling Holes in the product or improperly installing mounting brackets may void your SONY warranty and cause a safety hazard. Contact SONY or your dealer/installer for additional information. HT1F Front Channel Loudspeakers <2 ft. <2 ft. Direct view or rear projection TV. Front projection system. Place center speaker behind acoustically transparent screen. Alternate front speaker placement. Placement Tips · The left and right speakers should be at the exact same height, with the tweeter's height positioned at the midpoint of the screen. · The center channel speaker must be vertically oriented. Placing the speaker horizontally will result in less precise center channel performance. · If necessary, tilt the center channel so that the tweeters are aimed at the listening area. two. · Review proper operation of your receiver/processor. If there is very low or no output from one or more speakers, check the following: · Check the "Balance" control on your receiver/processor. · Check the surround level on your receiver/processor. · Check all wires and connections between the receiver/ amplifier and the speakers. Make sure all wires are connected and that none of the speaker wires are frayed, cut, or punctured. · Review proper operation of your receiver/processor. If the system plays at low volumes but shuts off as volume is increased, check the following: · Check all wires and connections between receiver/ amplifier and the speakers. Make sure all wires are connected and that none of the speaker wires are frayed, cut, or punctured. · If more than one pair of speakers is being used, check the minimum impedance requirements of your receiver/ amplifier. Specifications HT1F High Frequency Drivers 2 x 1" pure titanium Midrange Drivers 2 x 5" high polymer laminate Frequency Response 70Hz ­ 20kHz Recommended Amplifier Power* 10 ­ 130 watts Sensitivity 87dB @ 1 watt/1 meter Impedance 8 ohms Crossover Frequency 2800Hz Dimensions (HxWxD) 17-1/2 x 10 x 8-1/2 inches 445 x 254 x 216mm Weight 21 lbs/9. 5 kg XS-W3521 High Frequency Drivers 2 x 1" pure titanium Midrange Drivers 2 x 5" high polymer laminate Frequency Response 100Hz ­ 20kHz Recommended Amplifier Power* 10 ­ 130 watts Sensitivity 87dB @ 1 watt/1 meter Impedance Occasional refinements may be 6 ohms made to existing products Crossover Frequency without notice, but will always 2800Hz meet or exceed original Dimensions (HxWxD) 13-7/8 x 9-1/4 x 7-3/4 inches specifications unless otherwise stated. [. . . ] Make sure all wires are connected and that none of the speaker wires are frayed, cut, or punctured. · If more than one pair of speakers is being used, check the minimum impedance requirements of your receiver/ amplifier. Specifications HT1F High Frequency Drivers 2 x 1" pure titanium Midrange Drivers 2 x 5" high polymer laminate Frequency Response 70Hz ­ 20kHz Recommended Amplifier Power* 10 ­ 130 watts Sensitivity 87dB @ 1 watt/1 meter Impedance 8 ohms Crossover Frequency 2800Hz Dimensions (HxWxD) 17-1/2 x 10 x 8-1/2 inches 445 x 254 x 216mm Weight 21 lbs/9. 5 kg XS-W3521 High Frequency Drivers 2 x 1" pure titanium Midrange Drivers 2 x 5" high polymer laminate Frequency Response 100Hz ­ 20kHz Recommended Amplifier Power* 10 ­ 130 watts Sensitivity 87dB @ 1 watt/1 meter Impedance Occasional refinements may be 6 ohms made to existing products Crossover Frequency without notice, but will always 2800Hz meet or exceed original Dimensions (HxWxD) 13-7/8 x 9-1/4 x 7-3/4 inches specifications unless otherwise stated. 352 x 235 x 197mm *Undistorted continuous power Weight per channel. [. . . ]