User manual SONY XSF-1021

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. [. . . ] The t indication lights up and the power goes off; the player enters the standby mode. At the preset time, the power will go on and music will play. Then the power will go off at the preset time, and the player will enter the standby mode again. To check/change the waking up timer settings Press TIMER, then DISPLAY ENTER MEMORY. Each time you press DISPLAY ENTER MEMORY, a stored setting is displayed in the set order. To change the setting, display the setting you want to change and reenter it. To use the player before a timer playback starts If you turn on the player, you can use it as usual (in case of the radio, if you listen to the station which is different from the one you tuned in step 1 on page 29, you will hear that station at the preset time). Turn off the player before the preset time. To stop play Turn off the power. 30 The Timer Falling asleep to music You can set the player to turn off automatically after 10, 20, 30, 60, 90 and 120 minutes, allowing you to fall asleep while listening to music. SLEEP The Timer Tips · The display window does not light while the sleeping timer is on. · You can combine the waking up timer with the sleeping timer. Set the waking up timer first (see page 29), turn on the power, and then set the sleeping timer. · You can prepare the different music for the waking up timer and the sleeping timer. · When you select both sides recording, the recording will stop after the both sides recording finishes so that accidental recording will not be made. · The display window does not light while the recording timer is on. 8 Press STANDBY. The power goes off and the player enters the standby mode. The t indication and the recording side of the tape (front side ( or reverse side 9) appear in the display. To change the recording side, press STANDBY again. At the preset time, the power will go on and the recording will start. Then the power will go off at the preset time, and the player will enter the standby mode again. To check/change the recording timer settings Press TIMER, then DISPLAY ENTER MEMORY. Each time you press DISPLAY ENTER MEMORY, a stored setting is displayed in the set order. To change the setting, display the setting you want to change and reenter it. To use the player before a timer-recording starts If you turn on the player, you can use it as usual. Before the preset time, tune in the station you want to record and turn off the power. [. . . ] · Demagnetize the heads using a demagnetizer (see page 45). The tape player cannot be paused during playback. · The tape player can be paused during recording only. · The source which was recorded on TYPE IV (metal) tape using this unit is being played. [. . . ]