User manual SOUNDCRAFT DELTA THEATRE

[. . . ] With the optional Sonorus syncplate fitted a BNC wordclock cable should be connected from the Digital 328 wordclock output to the Sonorus syncplate wordclock input. Sonorus StudI/O ADAT Out 2 328 ADAT Out 2 328 ADAT Out 1 Sonorus StudI/O ADAT In 1 Sonorus StudI/O ADAT Out 1 ADAT In 1 328 328 Wordclock Out Sonorus StudI/O Wordclock In (Optional) 328 ADAT In 2 Sonorus StudI/O ADAT In 2 The ADAT connections allow digital transfer of either direct output for input channels 1-16 to the Sonorus StudI/O card, or the Digital 328's 8 Group outputs. Spirit Digital 328 v2 2 Digital 328 Setup Wordclock To configure the Digital 328 as the wordclock master, enter the 328 Menu pages by pressing the <MENU> button on the right hand side of the LCD display. Using the encoder beneath the display, scroll up or down until the `Clock Source Sel' menu is highlighted, and press <ENTER>. [. . . ] Using the encoder beneath the display, scroll up or down until the `Clock Source Sel' menu is highlighted, and press <ENTER>. Here, either the internal 44. 1kHz clock or the internal 48kHz clock must be selected, depending on the sampling rate at which work is to be done. Press <ENTER> to set the sample rate and <MENU> to return to the menu pages. 2 <Wordclock Src. > Internal:44. 1kHz or <Wordclock Src. > Internal:48. 0kHz To ensure that the Digital 328 Tape Ports are set to ADAT to work with the Sonorus StudI/O, enter the 328 Menu pages by pressing the <MENU> button on the right hand side of the LCD display. Using the encoder beneath the display, scroll up or down until the `Tape Port Select' menu is highlighted. Press <ENTER> and keep pressing the Up cursor arrow until the `<Tape Ch17-24 >' menu page is displayed. Using the encoder set the Bank Source to ADAT. If the backplate is fitted then you can also run the Sonorus StudI/O as a master device by setting the "Audio Clock Source" to Internal. When using this method you must connect a wordclock cable from the WORDCLOCK OUT BNC on the backplate to the WORDCLOCK IN BNC on the Digital 328. Ensure you select BNC from the "Clock Source Select Page on the Digital 328 to make it slave to the Sonorus StudI/O. Spirit Digital 328 v2 4 Audio Data The Sonorus StudI/O must now be set up to transmit and receive audio data to and from the Digital 328. Launch the ASIO devices control panel from the previous page. Here you can adjust the bit rate of the data passing to and from the Digital 328. For the highest quality results, select 24-bit, as the Digital 328 can send and receive all 24-bits. Please refer to the Sonorus StudI/O documentation for other system settings. Spirit by Soundcraft Harman International Industries Ltd. , Cranborne House, Cranborne Road, Potters Bar, Herts EN6 3JN, England. [. . . ] Launch the ASIO devices control panel from the previous page. Here you can adjust the bit rate of the data passing to and from the Digital 328. [. . . ]