User manual SOUNDTECH POWER SOURCE 800E

[. . . ] That the water inlet and outlet hoses are connected correctly; 3. That the dishwasher is level on the ground. It is worth it: for the longer life span and the correct operation of your dishwasher. 12) Learn to get to know the parts which make up your dishwasher, you will use it better for it. [. . . ] A Warning Three-in-one dishwasher tablets are now available on the market, and combine the detergent, salt and rinse aid all in one. If the water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser to prevent the formation of white streaks on your dishes or on the appliance interior. Add rinse aid to the corresponding container only if you are dissatisfied with the results on your dishes. In any case, please read the manufacturer's instructions provided on the packet. This product makes dishes sparkle more as it improves their drying. The rinse aid container is situated on the inside of the appliance door; you should refill it when you see the container is empty by means of indicator light “D”. (If your dishwasher is fitted with a “low rinse aid” indicator light, fill the container up when the indicator light flashes or lights up). To open the dispenser, turn cap C anticlockwise. Take care when you pour in the rinse aid to avoid it overflowing. You can adapt the amount of rinse aid used by the dishwasher: regulate the adjuster F which you will find under lid C. You can choose from six different positions. To select the right wash cycle, please consult the wash cycle table on page 17. ARISTON DISHWASHER - Instructions for installation and use 17 D ISHWASHER Afterhavingboughtormovedyourdishwashertoanotherhome, acorrectinstallation ensuresthatyourdishwasherwilloperatesmoothlyandefficiently. Choose where you want to install your dishwasher, you can even place it so that its sides or back panel are side by side with furniture or up against the wall. The dishwasher is provided with water supply and drain hoses, which can be directed towards the left or right to facilitate appropriate installation. Once the appliance is positioned, adjust the feet by screwing them in or out depending on how high you want it and to level it so that it is horizontal. Make sure that it is not inclined more than 2 degrees. If the appliance is level, it will help ensure its correct operation. Adjusting the back Feet Insert the appliance into the cutout and then adjust the height using the screws located on the front bottom part of the machine. Use a screwdriver to turn the screws in the clockwise or anti-clockwise direction to increase or decrease the height respectively. This electric household appliance should be connected to the water mains using the cold water supply hose provided with the appliance only. In the event of replacements, use original spare parts only. [. . . ] When the wash cycle has ended, always remember to turn off the water supply tap and to leave the appliance door ajar. This way, moisture and bad odours will not be trapped inside. Before carrying out any cleaning or maintenance on the dishwasher, always remove the plug from the electricity socket. When you go away for an extended period of time, we recommend you do the following: • run a cycle with the dishwasher empty • turn off the water inlet tap. [. . . ]