User manual STANTON DIGIPAK PRO

[. . . ] DIGIPAK PRO OWNER'S MANUAL S T A N T O N MA G N E T I C S , I N C information@stantondj. com + 1 954- 689-8833 www. stantondj. com IMPORTANT TO SAFETY 1. Read these Instructions Keep these Instructions Heed all Warnings Follow all Instructions Do not use this apparatus near water Clean only with dry cloth Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, hear registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] There is up to 10 seconds of anti shock protection available. 34) AUTO INDICATOR ­ Indicates when Auto Cue mode is active. 35) PITCH VALUE ­ Shows the percentage of the pitch slider. 36) PITCH ­ Indicates when the pitch percentage is displayed. TIME BAR ­ Shows a proportionate visual representation of the time remaining or time elapsed. TIME DISPLAY ­ Displays the time of track(s) currently selected in increments of Minutes, Seconds, and Frames. ELAPSED / TOTAL / REMAIN ­ Indicates whether the time shown on the display refers to total remaining time or track remaining time. If either of these are not illuminated, this indicates elapsed track time. RELOOP ­ Indicates when there is a previously set loop, and that the loop is ready to be played again. LOOP ­ Indicates when the CD is in loop mode. SINGLE ­ Controlled by the SGL/CTN button, this indicates when the unit is set to play just one track at a time. When this is not illuminated, the CD will play continuously through all tracks. 37) 38) 39) 40) 41) 42) SET-UP A) CHECKING THE CONTENTS ­ Check that the carton contains all of the following items. · Tabletop CD player unit · User's manual · One pair RCA cable · One power cable · One fader start / relay cable B) INSTALLING THE UNIT · Place the unit on a flat, level surface. · Be sure the player is in a well-ventilated area where it will not be exposed to direct sunlight, high temperatures, or high humidity. · Try to place the unit as far as possible from Tvs and tuners, as the unit may cause undesirable interference. · The player will work normally when the unit is within 15 degrees of the vertical plane. If the unit is tilted excessively, discs may not load or unload properly, or playback may be adversely affected. · The unit's LCD screen is designed to be clearly visible within the angles shown in the figure below. Place the unit so that the LCD screen is within this visual range for optimal clarity. C) CONNECTIONS · Make sure that the unit and any other equipment in the signal chain are turned off prior to making any connections. · Connect the RCA cable to the rear of the unit and to the input on your mixer. · Connect the power cable to the rear of the unit and to a proper AC outlet. [. . . ] · By creating a seamless loop with a very short duration. · By pressing PAUSE while audio is playing in CD Jog mode. SLEEP MODE The CD player automatically shuts off the transport and laser and displays "SLEEP MODE" in the LCD screen after being left in pause or cue mode for 15 minutes. This will lengthen the life of your motor drive, laser, and LCD screen. [. . . ]