User manual STANTON M.303

[. . . ] · To prevent overheating, always provide your mixer with adequate ventilation air space. · Avoid stepping on your mixer's AC cord. Repeated compression of the cord may lead to electrical shorting. · To avoid damage due to AC voltage peaks, always disconnect your mixer from the power source during electrical storms. [. . . ] The signal is routed to the line faders after the gain, EQ, pan, and effects. Crossfader - The crossfader is used to cross fade between channels 1 and 3. Kill switches - Kill switches are used to completely eliminate Hi, Mid, or Low frequencies from the audio. This can be used as an performance effect. Headphone outputs - This is the headphone output jack to connect your headphones. Cue pan - Fades the headphone output between the PFL signal (selected by the Cue Select buttons) and master output, effectively allowing the user to preview a mix. Cue level - Controls the volume of the headphone output. Booth level - Controls the booth output level. It is usually used for monitoring in a DJ booth, but can be used for various applications. Master output Pan- This is the pan or balance control for the master output. Master output level - Controls the overall output level of the mixer. Output meters - These LEDs let you know if the audio coming out of the mixer is loud enough (or too loud!). If the LEDs reach the red, the mixer is probably clipping, or distorting. Input selectors - These toggle switches select the input source between phono and line for each channel. Input gains - Controls the input sensitivity level of each channel. An LED meter is provided on each of the 3 channels for proper adjustment of the levels. Channel equalizer - Individual controls for high frequency, midrange, and low frequency equalization with +9dB/Kill adjustments. Note: Any changes made to EQ settings will change the overall output level. DESCRIPTION OF FUNCTIONS Power: This is the power switch to turn the mixer "ON" or "OFF" AC IN: This is the Input connection for the included power supply. Line: Line inputs (represented by the letter L, followed by the input number) are used to connect to line level sources such as CD players, Mini Discs, DATs, samplers, etc. TT: TT (or phono) inputs are used to connect to turntables. Ground: Connects to the turntable ground cable to eliminate electrical hum. Ground cables are usually supplied with turntables Master: Connects to an amplifier, EQ, crossover, or other outboard signal processing. [. . . ] To initiate a warranty repair, you must contact the authorized Stanton dealer from whom you purchased the merchandise, and follow such authorized Stanton dealer's return policy. Stanton assumes no risk and shall be subject to no liability for damages or loss resulting from the specific use or application made of the merchandise. Stanton's liability for any claim, whether based on breach of contract, negligence, infringement of any rights of any party, or product liability, and relating to the merchandise shall not exceed the price received by Stanton from your purchase of such merchandise. In no event will Stanton be liable for any special, incidental or consequential damages (including loss of use, loss of profit and claims of third parties) however caused, whether by the negligence of Stanton or otherwise. [. . . ]