User manual STANTON RM.416

[. . . ] RM. 416 4 channel Rack Mount MixeR user Manual important Safety instructions 1. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] - A green light indicates that the RM. 416 is receiving audio from a source device. - A red light indicates that the audio input level is clipping (over 0 dB). channel eQ: These rotary knobs control the frequency response of the selected inputs. HI: Adjusts the High frequencies from -15 dB to +10 dB (at 13 kHz). MID: Adjusts the Mid frequencies from -25 dB to +10 dB (at 1 kHz). LOW: Adjusts the Low frequencies from -25 dB to +10 dB (at 70 Hz). channel gain: Adjusts the level of the selected input from - to 14 dB. Microphone input (Mic): Connect a standard unbalanced 1/4 plug or XLR 3-pin balanced male plug. Input volume will be controlled by the 4th CHANNEL FADER. To monitor any source connected to these jacks, set the channel INPUT SELECTOR SWITCH to LN4. 4. aux 4 inputs (aux4): These inputs could be used to connect CD players, Tape Decks and other line level instruments. Input volume will be controlled by the 4th CHANNEL FADER. To monitor any source connected to these jacks, set the channel INPUT SELECTOR SWITCH to AUX 4. Ph/aux input (Ph3/aux3): You can use these Inputs to connect your turntable, CD players, etc. For example: - Connect your turntables and set the PH/AUX switch to PHONO. - Connect your CD players, Tape decks, iPods, etc and set the PH/AUX switch to AUX. To monitor any source connected to these inputs, set the channel INPUT SELECTOR SWITCH to PH 3/AUX 3. Fader Start control Jack (FaDeR): Connect the mini plug included with your CD player and press the FADER START button. This function allows the fader to activate or return to the preset Cue Point on your compatible CD player. gnD (gRounD teRMinal): To eliminate electrical hum, connect the ground cable from your standard turntable ground post to the RM. 416 ground terminal. Some turntables (like the Stanton STR8. 150) do not require grounding wire. channel line level Selector Switches (Ph/aux): These switches are used to change the voltage line levels of their related Phono/Aux RCA inputs jacks. [. . . ] However, if Tech Support determines that a repair is needed; please call us at +1 (954) 949-9600 to obtain a Return Authorization Number (RA#) PRIOR to shipping your product to us. Warranty Service outside the united States: To initiate a warranty repair, please contact the authorized Stanton dealer from whom you purchased your product, and follow the dealer's return policy. Save your shipping boxes and all packaging materials!For the fastest and safest product return to Stanton, please use the original shipping carton and packaging materials. [. . . ]